By using a master-slave J-K FF.
No
In Race round condition gate operation delay by signal but gate oprate first with clock ,this condition called the race raund confident
The "Race Around Condition" occurs when J+K=1 i.e. When the FF is in the toggle mode.the race around condition in JK latch can be avoided by:a) Using the edge triggered JK flip flop.b) Using the master slave JK flip flop.
by using master slave flip flop
The "Race Around Condition" occurs when J+K=1 i.e. When the FF is in the toggle mode.the race around condition in JK latch can be avoided by:a) Using the edge triggered JK flip flop.b) Using the master slave JK flip flop.
To remove a crown race using a crown race remover tool, first, place the tool around the crown race. Then, tighten the tool to grip the race securely. Finally, use a hammer to tap the tool gently, applying even pressure to remove the crown race without damaging the fork.
Any race because it is a skin condition
A race condition is an undesirable situation that occurs when a device or system attempts to perform two or more operations at the same time, but because of the nature of the device or system, the operations must be done in the proper sequence in order to be done correctly.
To remove the crown race from a fork, you can use a crown race removal tool or a flathead screwdriver and a hammer. Place the tool or screwdriver under the race and gently tap it to loosen and remove the race from the fork. Be careful not to damage the fork or the race during the process.
RACE AROUND CONDITION OCCURS WHWN BOTH THE INPUT ARE HIGHAND THE OUTPUT THUS UNDERGOES A TRANSITION STATE.FOR EXAMPLE CONSIDER THE INPUT VALUES IN A JK FLIP FLOP;ie;J=K=1 ,THE OUTPUT Q0=0 IN NORMAL CASE WILL CHANGE TO 1 AND VICE VERSA. THE REMEDY FOR RACE AROUND PROBLEM CAN BE ELIMINATED BY USING A MASTER SLAVE J-K FLIP FLOP'S
two or more processes are reading or writing some shared data and the final result depends on who runs precisely when, are called race condition.
Race Around the World was created in 1997.