To connect an RCA cable to an XLR cable, you must solder links one and three from the XLR together, and connect those two wires to the end of the RCA component, along with the second wire. It is very useful to use a diagram to make sure you connect the correct cables.
Depends, Self powered or not? home or car? XLR or RCA? Speakon or TRS JAck? or simple speaker cable.
You can purchase XLR to RCA connectors from the Guitar Center website. Alternatively, you can purchase these connectors online from the Amazon website.
XLR is a type of audio connector used in professional audio and video equipment. The three pin XLR is used universally for microphone and single channel audio signals. An XLR adapter is used to connect a professional audio signal to an alternative format. On a camcorder, it might be used to connect a low cost microphone or radio microphone receiver to the XLR input on the camera. One might be used on the audio output of the camcorder to connect to a domestic audio input that uses phono or RCA connectors.
It is used to connect microphone to microphone preamplifiers.
Between microphone and microphone preamplifier
To connect microphones to microphone preamplifiers
RCA
Normally it is so that you connect pins 123 normally, and connect pin 4 to pin 3 or leave it disconnected.
well if your connecting it to a computer u might just wanna try an xlr male to xlr female cable as your input, and a xlr male to 3.5mm jack (mini jack) to your computers audio interface...
If the system supports it, yes.
If you TV has output connection, then you can get cables to connect your TV to your projector. For example I have a TV with RCA video and audio outputs, I use 3 RCA cables and then I connect them to my RCA inputs into my projector. My projector has a small speaker, so most of the time I just connect the video cable.
XLR uses 3 pins, in order 1 = ground, 2 = hot, 3 = cold. You connect those to three pins in the 25 pins, but you need to check the manual of the connected unit which pins to connect them to.