answersLogoWhite

0


Best Answer

You could also use what is essentially dialysis to decrease the water concentration, placing your solution inside a dialysis bag with holes sized to be permeable to water. Then, you would place the bag in a solution that has a high concentration of an ion (salt for example). Water will attempt to balance the concentration gradient by rushing out of the bag. As long as there is nothing critical in the solution smaller in size than water, this technique should work.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

10y ago

Liauid water becomes less dense when it freezes, which is why ice floats.

This answer is:
User Avatar

User Avatar

Wiki User

11y ago

The density of water can be reduced by heating it. That increases the volume while the mass remains the same, therefore the density will decrease.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How can the density of boiler water be reduced?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does boiler blowdown means?

Boiler blowdown is required to prevent corrosion by removing impurities that contribute to its formation in a steam boiler and to facilitate the generation of pure steam by preventing the carryover of impurities. Why Boiler Blowdown is Required? Proper blowdown procedures are necessary to maintain the solids content of the boiler water within specific limits and to quickly eliminate contaminants if the water becomes contaminated.


What happens to water when it is heated up to 100 degrees?

The water becomes 100 degrees and is warm to the touch.


What is function of economizer in boiler?

Basically . economiser is located in between exit of boiler and entry of air preheater. when the flue gases are coming out from boiler they take away a lot of heat. economiser utilize this heat from flue gases. and these heat is used to heat the feed water which is going to feed the bolier. hence by using economiser the coal consumption required to heat the feed water is reduced hence cost reduced.


Why does water have reduced density when frozen?

An explanation is that during freezing the structure of the ice is modified.


When a submarine pumps water out of its flotations tanks its density decreases and it float. Why does its density decrease?

Density is weight divided by volume. Since the size of the hull stays the same, when the weight of the water is removed, the volume of the hull stays the same and the density is reduced.


At what size is a hot water heater considered a boiler?

NONE a boiler is a boiler and a water heater is a water heaterSEE ASME section IV or the NBBI


What is boiler feed water pump?

Boiler feed pumps are an important part of any boiler operation. They control the amount of water fed to the boiler and the manner in which it is fed.


What is fish boiler?

A fish boiler is a hous boiler that stores fish instead of water.


What is the explanation for the working of a benson boiler?

Benson Boiler is a water tube high pressure boiler having forced circulation. It works on the principle that if the boiler pressure is raised to critical pressure (225 kg/cm^2) then there is no formation of steam bubbles Because the steam and water at this pressure will have the same Density. To achieve this water is fed to the boiler at critical pressure . At this pressure water will be directly converted to superheated steam as the latent heat at critical pressure is zero. Overall efficiency of plant is decreased as a lot of energy is consumed by feed water. Operating the boiler at a slightly lower pressure than the critical pressure efficiency can be increased. Thermal efficiency upto 90% can be achieved.


Can you hook domestic hot water directly into your boiler?

No. Hot water directly from boiler is not potable.


Which is better fire tube boiler or water tube boiler?

The words are literal , a water tube boiler is water inside the tubes with hot gases surrounding them and a fire tube boiler are got gases within the tubes with water surrounding them.


What is the Function of economizer in boilers?

Basically . economiser is located in between exit of boiler and entry of air preheater. when the flue gases are coming out from boiler they take away a lot of heat. economiser utilize this heat from flue gases. and these heat is used to heat the feed water which is going to feed the bolier. hence by using economiser the coal consumption required to heat the feed water is reduced hence cost reduced.