Want this question answered?
You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.
Changing ball to goal in 6 steps: Change ball to bell. Change bell to belt. Change belt to bolt. Change bolt to boat. Change boat to goat. Change goat to goal.
To change the alternator belt an a 1985 Chevy Celebrity: 1. Loosen the adjuster bolt and the mounting bolt. 2. Move the alternator to release the belt tension and remove the belt. Reverse to reinstall a new belt.
You can change the bells on your snapper 17244 snowblower by loosening the tensioner bolt. Once the tensioner bolt is loose the old belt can be removed and the new belt put in its place.
on the alternator on top is a bolt losen that bolt and it will allow you to move alternator causing belt to losin
All you have to do is loosen the acessory that is driven by that belt. There is an anchor bolt and a pivot bolt that need to be loosened then the belt will slip off. Of course if the belt is "under" another belt, then you will have to remove that belt as well.
Release pressure on automatic belt tensioner
the tention pulley bolt is not stuck. It is supposed to be that way take a 1/2 " or 3/4 rachet or breaker bar and put it in the square hole and use the breaker bar to get leverage to move the tention bar so that tention is off the belt to rmove belt and do the same to install belt
To adjust or replace the belt first loosen the pivot bolt (through-bolt) at the bottom of the bracket. Next loosen the adjuster lock bolt and move the pump to allow belt replacement.
To change a belt in general: 1. Loosen the adjuster bolt and the mounting bolt. 2. Move the unit in so the belt can be removed. Note the routing of the belt. 3. Install the new belt, adjust the tension and tighten the bolts. If the belt you are changing is behind other belts you will have to do them in turn.
you have to loosen a bolt on the front of the AC compressor, I think its a 12mm. You loosen it and the the AC compressor will then be able to rotate downward, sometimes the compressor gets stuck with age and you might need to tap it down with a mallet. Once the compressor rotates downward the tension in the belt will be gone and you can change the belt. Then tighten the same bolt until you achieve the desired tension
To change the alternator belt on a 1998 Mazda 626 you need to first loosen the bolt that is located in the center of the adjustment pulley. Next, turn the adjustment bolt to the left until the belt is loose and can be removed. Reverse the steps to replace with the new belt.