Fuel pumps are built into most gas tanks and then run on an electric motor that draws power from the battery. While working, it sends the right amount of fuel through the fuel lines and into the engine. When it doesn't work you will notice a lack of power during peak performance, and slow or hesitating starts. But there is a way to check whether your engine problems are due to a bad fuel pump.
You need spark plug tester for this purpose.
I have a tom tom myself but if the screen is not working I would check to see if you still have a warranty on it.
check to see if the evaporater is working or if its leaking, then check for leaks on ac lines going threw out ur engine bay
Yes, if you are still working at the job that provides the insurance. When I was in college the health center offered a cheap student health insurance. Check and see if yours does.
Chublets!
Check the electric fan to see if it is working.
first check your coolant level. then check to see if you have a leak, then check to see if you cooling fans are coming on then check if your thermostat is working.
Check if all fuses are working and see if there is any circuit short. Also check if the ignition switch is in a proper working condition.
The best way to troubleshoot why the taillights are not working on a 1999 Toyota Corolla is to first check all of the bulbs to see if one is burned out. Then check the fuses to see if there is a blown fuse. If the problem is still not found, a code reader in the ECU (computer) might show a code that will help find the problem.
Take it out and dunk it in boiling hot water. If it opens it'a working.
Compression check. S-series see around 180 psi to be considered in good working order Compression check. S-series see around 180 psi to be considered in good working order
Check the USB port to see if it is still working. Check to make sure the batteries are good.
Since you replaced the sensor, and the speedometer still isn't working it is possible that you will need to replace the speedometer cable. Check the cable first to be sure that it is still properly connected, and if so replace the cable to see if that solves the problem.