0
How can you check the correct order of disconnecting parts and cable from engine before removing it?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace a starter on a 85 cutlass?
The starter on a 85 Cutlass is replaced by disconnecting the battery, unbolting the starter, disconnecting the wires at the starter, and removing it from the vehicle. The new starter is then wired up and bolted to the engine block.
How do I remove a dodge neon transmission?
The transmission on a Dodge Neon is removed by removing the axles, disconnecting the wiring harnesses, and unbolting it from the engine block. It can then be shifted away from the engine and lowered from the vehicle.
When do you change the transmission on a 2006 Dodge Durango?
The transmission on a 2006 Dodge Durango is changed by removing the drive shaft, disconnecting the linkage, and unbolting it from the engine. It can then be lowered from the vehicle and replaced.
Before removing the radiator cap what must you ensure?
That the engine is cool.
Turn off engine light Honda 2002 civic?
To turn off a 2002 Honda Civic engine light it needs to be reset. Resetting the light can be done by either disconnecting the battery or removing the ECU fuse.
Will disconnecting a battery cable cause a 2009 Chevrolet Cobalt's engine to stop running?
Yes, and disconnecting the battery while the engine is running can severely damage the computers
How do replace a water pump on a 2002 Hyundai accent?
The water pump on a 2002 Hyundai Accent is replaced by removing the engine accessories, disconnecting the radiator hoses, and unbolting the pump. A new gasket and pump can then be attached.
How do you steps on replacing intake manifold gasket on a 1998 Chevy venture?
extremely difficult without removing the engine. i have seen some drop the engine down about a foot by disconnecting the motor and transmission mounts & did not disconnect alot of lines and were able to change the intake gasket.
How do you change the water pump on a 1994 Chrysler concord?
The water pump on a 1994 Chrysler Concord is changed by removing the engine accessories, disconnecting the radiator hoses, and unbolting it from the engine block. The surface is then cleaned, a new gasket installed, and a replacement water pump mounted.
How do you reset the check engine light in a 1989 corvette?
You can reset the light by disconnecting the battery for 10 minutes. It will come back on again if you do not correct the problem that set the light in the first place.
How do you reset a service engine light on a 1999 trailblazer?
Service engine lights need to be read with a code reader for your make and model. If the problem has already been fixed, you can reset the light by removing the appropriate fuse, or disconnecting the negative battery terminal for at least 30 seconds.
How do you replace water pump on a91 ford f-150 6cyl 4.9l?
The water pump on a 91 Ford F-150 6cyl 4.9l is changed by removing the engine accessories, disconnecting the radiator hose, and unbolting the pump. It can then be pulled from the engine and a new pump installed.
