A flashing check engine light means an engine cylinder misfire has been detected
Fix the problem it is telling you about - It will jsut come back on if you dont M
I have a 2002 Millenia-S and removing and reattaching the + battery cable does reset the check engine light.Answertry unhooking the positive cable to the battery...this works on my 97 millenia
A flashing check engine light is usually due to a misfire. see related questions below.
Button on the shifter.
you need an on board diagnostic scaner
pretty sure its under the passenger side head light
This was happening to me and the check engine light came on as well. I had to have my catalytic converters replaced, there are two on the 2002 Millenia S.It cost about $2,000.00 at the dealer and parts had to be ordered. This was happening to me and the check engine light came on as well. I had to have my catalytic converters replaced, there are two on the 2002 Millenia S.It cost about $2,000.00 at the dealer and parts had to be ordered.
flashing check engine lite means do not drive, or you risk permanent engine damage. you need to get the codes scanned
NO. if you replace the fuel filter, it will have NO effect on the flashing ce lite. how bout get the codes scanned, and THEN see why it is flashing? using the guess method to diagnose a problem with the millenia doesnt work
you need to change the input turbine speed sensor
Depnds on the code
Either buy a reset switch from a motor factor or get your local dealership to clear it.
It can be a lot of things, more than likely a cylinder is misfiring, but you will need to have a computer hooked up to it to be sure. It could be something simple like a wire.
The check engine light on a Mazda Tribute gives warning of potential problems. It can signal overheating, low oil, or engine misfires.
could be a blown fuse or you could check by the break caliper your abs lines are there make sure the lines are not broke ripped torn etc. the lines lead to an abs sensor check the sensors make sure they are functioning properly
The check engine light on a Mazda CX7 can be turned off by attaching an OBD II code reader. It can both read the engine codes and turn off the check engine light.
how to reset check engine light on 1992 Mazda mpv
on my 02 millenia the check engine light is also on. i work for a dealership,so i plugged in the ecm reader(ecm is the cars computer) and it read out that my egr valve was bad. as long as the light isn't blinking than u either have bad o2 sensor or the egr valve. either one being bad will only cost u a mile or two on ur gas mileage.
There is no dedicated fuse for the light.
You have to pull off the front bumper 1st. Then after you pull off the front bumper, then you have to disconnect the whole light from the car. After that you can replace the bulb.
If the check engine light is blinking , an engine cylinder misfire has been detected