There is some information missing in the question, so the answer will need to make some assumptions.
"Three cables" is probably referring to three pairs of audio cables or three sets of video and audio. Each of the cables will have a red connector, a black or white connector and a yellow one if they carry video. The set of phono sockets is probably referring to two or three sockets that one cable can plug into.
To connect three different sources into one input, a switcher is needed. This can be a simple unit costing only a few dollars or pounds but it might be a more sohisticated audio and video theater amplifier. Whichever one is chosen, it will allow one of the three signals to be selected.
To connect a single output to multiple inputs, the audio signals can be taken to simple phono splitters and on to the three inputs. If a video signal is being used, that will require avideo distribution amplifier. Most electronic stores will be able to supply one. Radio Shack in the US and Maplin in the UK will have them along with many other stores.
Phono cables can be purchased through most electronics stores like Fry's Electronics. They can also be purchased online through sites like NewEgg and eBay.
He had one brother named jesus
You need two cables called IDE cables. Typically these cables have the ability to connect two hard drives or two CD DVD roms. So just find two IDE cables and you can conect what you need to connect.
i assume the two red cables are for the positive and the black one single for the negative
It is possible for one to make their own extension cables by separating two or more cable chords, and using a series of male and female outlets and sockets, to combine their length.
Disconnect the cables at the 1998 4runner battery. Follow the cables to the other ends, paying attention to the path that they follow. One at a time disconnect the cable end, pull it out, then connect the non batter end. Connect the cables to the battery to finish the installation.
A phono cartridge or magnetic cartridge is actually a transducer or converter. With it, you can play gramophone records on a phonograph or a turntable.
A UTP coupler is a small block to which you can connect two UTP cables to form a longer one. Handy if you have 2 short cables but need a long one.
Usually when people talk about a phone cable or a phono cable they mean a 1/4" cable. Mono mean that it only caries one signal with it (a hot signal and a ground, Or + and - ). Thus it has two pins on it. A stereo cable would have three pins so it could have two separate sounds (one for each ear). They call them phone cables or phono cables because i believe they used to use them in the old phone switchboards in the past. So get a 1/4" male mono cable.
Yes CAC6 is one of the best.
Yes but you will need HDMI cables.
well yes they are completely different cables, and the hdmi cable only has one cable to connect were for the component cables you have to plug in 5 different cables, but as far as quality i would say they are the same