0
What else can I help you with?
Connect three or more monitors to a laptop?
You need special cables!
Starting with jumper cables 1997 Sebring JX?
1. Connect one end of positive cable to "dead" battery post. 2. Connect opposite end of positive cable to "good" battery post. 3. Connect one end of negative cable to "good" battery post. 4 Connect opposite end of negative cable to ground (not battery post) on "dead vehicle. After "dead vehicle starts, allow to run at least three minutes before disconnecting jumper cables. Disconnect the jumper cables in the opposite of connection: 1. neg cable from "dead" ground. 2. neg cable from "good" batt post 3. pos cable from "good" batt post. 4. pos cable from "dead batt" post. If you follow the recommended procedure, you will minimize the risk of "frying" the computer.
What types of cables are used in paired connection of computers?
There are three types of cables used in paired connection of computers: crossover, straight-through, and rollover. Crossover cables are used to connect two devices directly, without a router or switch in between. Straight-through cables are typically used to connect a computer to a router or switch, while rollover cables are typically used to connect a modem to a router or switch.
How should three 6 volt batteries be connected?
If you connect them in series it will result in an 18V battery. If you connect them in parallel you will have a 6V battery with more capacity than one alone.
How do you install a starter on a 1967 Corvette?
Bolt the starter into the starter position. There will be three starter retaining bolts. Connect the cables to the front of the starter.
On a dodge magnum 318 their are three cables on throttle body two are for adjustment the one closest to body has slack how do you adjust it and what is its purpose?
The three cables are from the gas pedal, cruise control, and transmission kick down. The transmission kick down is the only adjustable cable.
Where is the throttle position sensor located in a 1997 dodge ram 318 1500?
It is the three wire sensor on the throttle body opposite of the throttle cables.
How do you change a battery in a buick rendevous 2002?
First you have to remove the bar above the battery [It has three bolts] one behind the fuse box and two above the radiator. Then Remove negative and positive cables. The battery has a battery hold with one bolt located at bottom behind the battery. finally lift and replace battery.
2002 dodge status Chang the battery?
Jack the front driver side up -remove the tire -under fender in the front there is a fender skirt with plastic push pins and three hex screws on fender-remove pins with screwdriver and remove 3 screws-pull skirt from under fender -battery has 2 nuts on holding clamp remove these and detach neg and pos cables-battery slides out -installation is reverse procedure.
Can you connect a car battery to a three wire cable?
Sure, just use 2 of the wires and ignore the 3rd one.
What are the Three types of physical cables that carry a signal?
fiber optic cables, coaxial cables, and twisted pair cables.
How can someone connect an rca to xlr?
To connect an RCA cable to an XLR cable, you must solder links one and three from the XLR together, and connect those two wires to the end of the RCA component, along with the second wire. It is very useful to use a diagram to make sure you connect the correct cables.
