answersLogoWhite

0

1. Connect one end of positive cable to "dead" battery post. 2. Connect opposite end of positive cable to "good" battery post. 3. Connect one end of negative cable to "good" battery post. 4 Connect opposite end of negative cable to ground (not battery post) on "dead vehicle. After "dead vehicle starts, allow to run at least three minutes before disconnecting jumper cables. Disconnect the jumper cables in the opposite of connection: 1. neg cable from "dead" ground. 2. neg cable from "good" batt post 3. pos cable from "good" batt post. 4. pos cable from "dead batt" post. If you follow the recommended procedure, you will minimize the risk of "frying" the computer.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the throttle body on a 1997 Chrysler Sebring 3.0L?

It is the part between the intake and the air cleaner. It has electrical sensors and cables attached to it.


Will a 1997 sebring coupe hood fit a 1997 sebring sedan?

No.


Where is the cabin filter on a 1997 Chrysler Sebring?

A 1997 Sebring does not have a cabin filter.


What are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi?

what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi


Will a 2001 Chrysler Sebring fender fit on a 1997 Chrysler Sebring?

No,No,


Will a valance and grill from a 2002 Sebring fit a 1997 Sebring JXI?

No.


Will 2002 Sebring door handles fit a 1997 sebring?

No.No.


97 sebring loses power and stalls at low speed?

There could be a few reasons why a 1997 Chrysler Sebring loses power and stalls at a low speed. The thermostat could be bad, the battery cables could be lose, or a spark plug may need changed.


How long will a 1997 Chrysler sebring's engine last?

I have a 1997 Sebring Convertible. Engine is currently at 152,000 miles and still going strong.


Where do you put jumper cables on an Audi A8?

A8s in the 1997 to 2003 vintage all have batteries in the trunk. Open trunk, remove flat, carpeted cover plate from the right, rear corner of the trunk. Hook jumper cables to the exposed battery terminals. Use a flash light to ensure you identify the + & - terminals properly. The wiring colors are tricky in this case. USE THE FLASHLIGHT.


Is there a fuel reset on a 1997 Chrysler Sebring JXI If so where is it located?

A Chrysler Sebring does not have a reset switch.


How many seats in a Chrysler Sebring convertible?

I just got a 1997 Sebring convertible and it has 4 seats. I have a friend with a 06 Sebring and it Also has 4