If you look to the left side of steering column, you will see the quarter holder and a flat looking plate- if you push in on the top of plate it will brighten the dash lightsand by pressing the bottom of it : it will dim the dash lights. The bad thing I have found is that you have to bighten or dim them every time you turn the lights off and back on. should do this while setting still as it is akward to doing while driving.
lights are apparently (according to haynes manual) soldered in.
It's that part in front of the driver with the lights and gauges, radio, glove compartment, etc.
loose battery connection, or dead battery.
The lights that light up your gauges. . . I don't think those are the lights being asked about. More likely you are inquiring about the service and warning lights.
it could have to do with the preasure systems. or your gears may be grinding. go to your machanic and check it out :p
It has no fuse you have to replace the bulb/s itself
Roll Stability Control
A cracked wire or worn insulation may cause intermittent stoppages.
Turn on headlights/parking lights and adjust dimmer control
It depends on which lights are being described. Some of them will be for gas, others for oil change, and then some for other issues.
Fuse should be marked and also control parking and tail lights
Its the fuse and if not its the fuse Boxs. by the cluch or brake peddle.