You can always check to see if the plugs are sparking. Get an inline spark checker. Harbor freight 3 bucks. Hope this helps.
Inside the distributor!
its inside the distributor
why is my dash board lights not working
the faulty part is actually located in the distributor so you need to replace the whole distributor
The module is located behind the Rotor Arm assembly in the distributor itself. You have to remove the Distributor Cap, then the Rotor Arm and the module is there.
It could be either the crank angle sensor or the distributor module. If it is the distributor module, you have to buy and install a re-man distributor.
No there is not, Probley need to replace ingnition module in the distributor if the injectors are not working.
Need to replace the ignition module in the distributor, If you are sure the fuel pump is working.
The ignition module is located in the distributor, under the distributor cap.
ignition module is located under the distributor, where the spark plugs come out to go to the spark plugs, remove 6 bolts that hold the 3 capped distributor on, unplug the wires from both ends of module, 3 plugs, lift module out, nothing holds it in after distributor is removed, plug new module in, replace distributor.
The ign. control module on a 2.8L s10 is in the distributor. Remove the distributor cap and it is attached to the base of the distributor
The 327 cubic inch Chevrolet's distributor had points and condenser and not an ignition module. If you have an ignition module then you have a HEI distributor that was changed out.