0
What else can I help you with?
1993 Chevy lumina euro 3.1 will not start no spark no power going to the ignition module from computer what is the problem?
Check your fuses
What degree should the timing be set on a 1971 Chevy 307 with electronic ignition?
8 Degrees BTDC. ( before top dead center )
Where is the Electronic Control Module located on a 1996 Chevy Beretta and how can you tell if it is bad?
try looking under the glove compartment try looking under the glove compartment
Where is the ESC module on a 1989 GMC C1500 V8 and with a code of 43 should it be replaced?
(ESC) Electronic Spark Control Module on 89 Chevy should be mounted near the throttle body of the TBI. May have letters HKR stamped on it.
What is wrong with a Chevy Blazer that dies when it is hot outside but starts back up after a minute or two and runs great when it is not hot outside?
sounds like the ignition module is failing in the heat.
Why want the 93 Chevy Caprice classic want start?
electronic ignition module
Were is the electronic ignition module at on your 1996 Chevy s10 truck?
If this is the 4.3 engine, it is located on the bracket next to the ignition coil.
Would like info on ignition troubleshooting for 92 Chevy Suburban?
test ignition coil,ignition module,pick-up coil,electronic spark control,and knock sensor
Where is the ignition control module 1997 Chevy cavalier 2.2 L?
where is the ignition control module loacted on a 1997 chevy cavalier
Where is the ignition module on a 1986 Chevy Celebrity?
On the V6 the ignition module is under the distributor cap.
Why does my 1989 Chevy 350 ignition module keep going bad?
If you're not using a heat sink grease between the module and the mount area try using some on your next replacement module.
How do you replace the Ignition Module in the Chevy Celebrity?
To replace the ignition module in your Celebrity: Unplug the wires, take note of where they go so you can put them back in the correct place. Remove the screws that hold the ignition module in place. If the old module was coated with dielectric grease on the mounting surface put fresh dielectric grease on the replacement ignition module. Put the new ignition module in place and attach with the screws. Plug the wires back in their respective places.
How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
Where is the ignition module on a 1999 4 cylinder Chevy S 10?
The 1999 Chevy S 10 pickup truck ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
How do you bypass the ignition module to crank a 2000 Chevy blazer 4.3?
It will not run if you bypass the ignition module (no spark).
Where is the ignition control module for 1997 Chevy Cavalier 2.4L?
The ignition control module is located under the electronic ignition control module cover. On a 1997 2.4L cavalier, it will have the words 2.4L twin cam stamped on it. It is on the top of the engine and is held in place with four bolts. This cover must be removed to get to the spark plugs.
Where is the ignition control module located an a 1983 Chevy blazer?
Where is the control module located on the 1983 Chevy blazer
