If you're not using a heat sink grease between the module and the mount area try using some on your next replacement module.
Which engine does your car have?
On a 2.8l v6 it is at the front of the engine behind the ignition coils.
You can replace the ignition control module and the crankshaft position sensor as required.
where is the ignition module located on a 1988 Mazda b2200
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
ignition control module is located under the distributor cap
Behind the coil pack in the front lower center part of the engine.
how do you install new ignition switch on 1989 chevy G10 van?
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
No spark in your 1989 Chevy Celebrity 2.8 V6 is usually caused by either: A failed crankshaft position sensor. A failure of the ignition module. A failure of the engine control module or associated wiring.
The ignition module on a 1989 5.7 liter is located in the distributor. Remove the cap, then the rotor, and you will be looking at the module. The module is held in place with two screws. Real simple. Good luck, David
The engine computer is the ignition module. It is the large black box under the hood.The engine computer is the ignition module. It is the large black box under the hood.