answersLogoWhite

0

ignition control module is located under the distributor cap

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the ignition module on a 88 tracer?

ignition control module is under the distributor cap


Where is the ignition module on a Mercury Tracer 1997?

On a 1997 Mercury Tracer, the ignition module is typically located near the ignition coil, which is mounted on the engine. You can find it on the driver's side of the engine compartment, often near the firewall or close to the intake manifold. For easier access, it may be necessary to remove other components, depending on the specific engine configuration. Always consult a repair manual for detailed instructions and diagrams specific to your vehicle.


Where is the thermostat located on a 1996 Mercury Tracer?

Need to know where is the thermostat located on a 1996 mercury tracer.


Where is thermostat located on a 1996 mercury tracer?

Need to know where is the thermostat located on a 1996 Mercury tracer.


Where are the constant speed control modules located on the '99 Mercury Tracer?

If you mean the Constant Control Relay Module, it is located under the air filter.


How do you set the ignition timing on a 1994 mercury trio tracer?

You can't. Computer sets it. Chuck the Tracer pro.


Where is the transmission over fill plug located on transmission in 1996 mercury tracer?

where is the transmission fill on the mercury tracer


How to set the ignition timing on 91 Mercury Tracer?

can't. computer does it automatically.


Setting the ignition controle module on 1991 Mercury Tracer?

can't be set. only replaced. and that isn't your problem anyway. replace the crank position sensor, or the fuel pump. then your 1.9 will start.


How do you replace ignition lock cylinder on a 1996 Mercury Tracer?

Begin by removing the retaining ring at the top of your 1996 Mercury Tracer ignition switch. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the cylinder. Reverse the process to install your new ignition lock cylinder.


Where is the relay control module on a 1997 mercury tracer?

The relay control module on a 1997 Mercury Tracer is typically located in the engine compartment, near the battery or the fuse box. It may also be found on the driver's side, towards the rear of the engine bay. For precise identification, it's best to consult the vehicle's service manual or a repair guide.


How do you remove the ignition tumbler in a 1995 mercury tracer?

3 screws facing the engine