increasing voltage
When a capacitor is connected to a circuit, the current flow through the capacitor initially increases and then decreases as the capacitor charges up.
When a capacitor is discharging, current is flowing out of the capacitor to other elements in the circuit, similar to a battery. Current flowing out of an element, by convention, is defined as negative current, while current flowing into an element, such as a resistor, is defined as positive current. Thus a discharging capacitor will always have a negative current.
In an electronic circuit a capacitor can be used to block direct current. In general a capacitor stores electric charge. The charge in a capacitor is the voltage times the capacitance and that is also equal to the charging current times the time (all quantities in SI units - seconds, volts, amps, coulombs, farads)
In steady state, the current through a capacitor is zero because the capacitor blocks the flow of direct current (DC) once it is fully charged.
No, a capacitor can not be used as a fuse to limit an overload current condition.
When a capacitor discharges the discharge current flows in the opposite direction to the current used to charge it.
What happens to the current in a circuit as a capacitor charges depends on the circuit. As a capacitor charges, the voltage drop across it increases. In a typical circuit with a constant voltage source and a resistor charging the capacitor, then the current in the circuit will decrease logarithmically over time as the capacitor charges, with the end result that the current is zero, and the voltage across the capacitor is the same as the voltage source.
when the DC current flows through the capacitor .the leakage of the charges is in capacitor called Dc leakage capacitor .
It increases. The time constant of a simple RC circuit is RC, resistance times capacitance. That is the length of time it will take for the capacitor voltage to reach about 63% of a delta step change. Ratio-metrically, if you double the resistance, you will double the charge or discharge time.
The relationship between capacitor current and voltage in an electrical circuit is that the current through a capacitor is directly proportional to the rate of change of voltage across it. This means that when the voltage across a capacitor changes, a current flows to either charge or discharge the capacitor. The relationship is described by the equation I C dV/dt, where I is the current, C is the capacitance of the capacitor, and dV/dt is the rate of change of voltage with respect to time.
AC current can flow through a capacitor, it's DC current that can't
No.