# Replace the door. # Patch the door. # Install a hole cover. # Install a closet handle.
A door hole filler plate is used to cover up unwanted holes in a door, such as those left behind by removed locks or handles. It serves the purpose of providing a clean and finished look to the door. The filler plate is installed over the hole and secured in place, effectively concealing the opening and restoring the door's appearance.
It may be left in the hole to indicate the holes position but tended, it must be removed immediately the ball has been struck
I hope this helps as I had problems with my 1991 Aerostar sliding door not opening. I had to remove the door panels (Bottom one was hard to get out, Top one left to hang). With the door panels removed I was able to see the door mechanism only at the front were the handels were. I traced were I believed the rod went and made a small hole (1-2 inches) close to the back of the door were there had been a hole for a door Panel screw. I was able to see the rod that triggers the mechanism to open the door. It was attached to an "L" shaped peice that was bent out towards the outside of the door. By carefully bending it back strait I was able to get the door working again. After getting the door open I was unable to see any other way to get to this bent piece without makeing this hole.
Go to the left and fall down the hole. when you reach the very bottom go to the left out the door.
Use Cut on the door, when inside the cave fall down the first hole then your in a room with 4 holes fall down each hole in this sequence: Up, Left, Right, Down.
1. left door 2. left door3. right door4. through the hole on top of the painting
When the scientist is not in front of the door, use Cut in front of it. when you go down the hole, here is the pattern up left right and/or down
Under seat on left side of bike is small key hole
You need to use cut on the front door, then go down the hole. When your there go down the top, left, right and then the bottom hole and you should end up at the sapphire or gem thing.
Move the barrel. Open the hole in the top left corner and grab the ball. Flip your device upside down and the door will open.See related link for screenshots.
you need to buy a hood opening lever and there is a hole on the left side of the dash on the end that touches the door use it in this hole and the hood will open
One door from the restroom has been removed. Cut the dumpster lock with the bolt cutters from Puerto Rico (upper left star), and bring the junk door back onto the restroom. (Besides directions, you need matches from the pub and a lantern from the Himalayas.)