0
you can take a siren from a home security device, not a speaker but a siren cause a siren works of voltage and a speaker works of wattage. take a battery that is capable of working the siren then just put the the siren in series with the battery and then take the two wires and put one on the open side of the battery and the other wire on the open side of the siren. If the siren goes off there is continuity between the two wires your testing if the siren dont then there is no continuity.... good luck..
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
This device tests continuity of a copper cable?
A continuity tester.
What can be tested with a continuity tester?
A continuity tester determines if an electrical path can be established between two points. This is a great tool for mechanics, architects, and electricians.
What are the advantages of continuity tester?
A: Motherboards and even cards have lines running in all kinds of way in close proximity. a continuity tester not only checks for continuity but also for shorts to one point to every point on the item submitted
How do you check for a short in your car wiring?
You must check for continuity in the wiring. You will need a voltage/continuity tester. place one lead at one end of the wiring and place the other at the opposite end of the wiring. If the continuity tester does not indicate a constant flow of continuity it will NOT light up or "sound off."
When used on a copper based cable a continuity tester applies a small amount of what to each conductor?
When used on a copper based cable a continuity tester applies a small amount of ______ to each conductor?Voltage
How do you check a double 30 amp fuse?
Remove the power then remove the fuse. With an ohmmeter put the leads on both ends and read the meter. If it shows "zero" then the fuse is good and can conduct electricity. If it shows anything else than the fuse is defective and needs to be replaced.
What instrument measures continuity?
A continuity tester, aka test light. Its a simple ohmmeter with a go/no-go indicator (often a light bulb).
Can a DMM be used as a simple coax tester?
You can use the DMM to test continuity in the cable.
What would you use to verify that your new cable meets Cat 6 standards?
A. Continuity Tester
What tool would you use to verify that your cable meets Cat 6 standards?
A. Continuity Tester
How can you check if a power window switch is good?
use a continuity tester on the switch itself just hold contacts on tester to contacts on switch and if it reads with a beep or a light your switch is good pending the tester is accurate
When used on a copper-based cable a continuity tester applies a small amount of what to each conductor?
voltage
