answersLogoWhite

0


Best Answer

Of course

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How can you make water flow without pressure?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does increasing pipe diameter increase water flow?

well it depends it could but for it to make a difference you will need more water pressure.


Underwater pressure--Can you make water flow upward continuously if you vertically submerge one end of a 1-inch pipe 10 meters or more under seawater?

Yes....that is the water will flow up the pipe until it reaches the level of the water and stop. I don't get it. At the surface level the pressure is supposed to be 14.7 psi; doubled at 10 meters deep. If submerging a pipe deep enough for a significant pressure difference, can we harness the continuous upward flow of water for some application?


How do I turn-on water supply to hot water boiler it is heating but nothing goes to the radiators?

Check your gauge to make sure you have enough pressure and your flow control valve is not stuck


How do you make water reboil without heating or removing the top?

Water boils when saturated vapor pressure of the gas molecules of water is equal to the atmospheric pressure. In order to maker water boil at these conditions, the pressure at the top of the liquid should be reduced using a vacuum pump


What amount of water make a higher note in a glass?

THE GLASS WITHOUT WATER MAKE A HIGHER THE GLASS WITHOUT WATER MAKE A HIGHER THE GLASS WITHOUT WATER MAKE A HIGHER THE GLASS WITHOUT WATER MAKE A HIGHER THE GLASS WITHOUT WATER MAKE A HIGHER


How much current is need for 12 VDC to flow through water?

First thing voltage does not flow current does. Voltage is the potential or pressure needed to make the current flow. Current is directly proportional to the applied voltage and inversely proportional to the resistance of the circuit. To make the current flow you have to adjust the resistance of the circuit and that would be the water in this case. Salt added to water will make the water conductive so the resistance can be adjusted thereby making the current rise or fall depending on the water solution's resistive properties. The equation that you should consider using is Amps = Volts/Resistance.


How does push to make switch work?

Push-To-Make switch is a switch in which pressure is applied to the switch for it to let the electricl current flow through.


What forces act on a dam?

Lateral forces from water act on the damn. To find a point load on a damn, ypu must find the centre of pressure. How much pressure depends on velocity, flow rate, depth and the specific gravity of the water. the force is tension because the dam is stuck to something and the water pushes this to make it expand.


Why does marijuana make your eyes low?

Because it decreases pressure in the eye and increases blood flow


What analogous condition for the sustained flow of charge in a wire?

For example, you can make an analogy with the flow of water in a tube.


What is the function of the impeller in a centrifugal pump?

Impeller make the flow has velocity in a centrifugal pump. The purpose of pump is increasing the pressure. The flow has velocity envergy via impeller and the energy change to pressure energy in diffuser.


Does a one knob shower control or two knob control make a difference on the water pressure?

Neither one will make any difference in water pressure.