0
What else can I help you with?
How can you open your hood on your 95 Pontiac transport if the cable is broken?
Reach under the front of your car between the radiator and the grill and pull the wire down. That will unhook your hood latch. Replace the cable.
How do you release Bonnet on Citroen Synergie with broken release cable?
Hi climb under the front of the car with a pair of pliers, reach up and pull the release.
Broken hood release cable on 1990 Buick Century how do you get the hood open?
You can take the front grill off, with some T20 screws on the front of the car. You will see the hood release cable, and the mechanism that it attaches to. Just look at it, and you will be able to figure out how to open it from there.
How do you get the hood up on a Buick LeSabre when it will not release to the safety catch?
That depends on a few things. If the cable has broken at the release handle, you can use Vice Grips or pliers to grab the end of the cable and pull. If the hood is stuck down you can have a helper pull up on the hood while you work the release in the car. If the cable has broken at the latch consult a pro for help. If you get a helper to hold the the hood release open on the inside and tap lightly, with the side of your fist, on the front of your hood just above the grill. This will usually work if the cable is not broken.
1992 Oldsmobile Achieva how do you hood if release cable is broken?
Go underneath the front of car by the grill.Look up towards the hood latch.In the middle is a switch.Push it to the left and the hood should release.
How to manually release hood on buick regal that the interior switch has been broken?
it is next to drivers side on floor in front, take pliers and pull up on cable, this will release hood latch
How do you open the hood on a 1998 Plymouth Breeze when the release cable is broken?
reach thru front grill with long pair of needlenose plies grab cable and pull towards driverside headlight....email me at brianmech38@yahoo.com
How would you open the hood of a 1997 SC1 Saturn with a broken release cable?
look under the dash and find the broken end peel the case back until you can grab the broken piece with vicegrips then pull someone pushing down on the front of the hood will help release it do this all at the same time
How do you fix the Front seat of an Audi a3 3 door that won't push back..... I think the cable is broken?
Replace the cable.
Mr2 spyder cable broken how can you unlach the hood?
If the hood latch cable on your MR2 Spyder is broken, you can manually release the hood by reaching through the front grille. Use a long, thin tool like a screwdriver or a coat hanger to push the latch mechanism. Alternatively, you can remove the front bumper to access the latch directly and release it that way. Always ensure to handle the latch gently to avoid causing further damage.
If a 1994 Camry 4 cylinder with automatic is stuck in second gear how do you fix it?
See if you can locate the cable that goes to the lever on the front of the transmission and determine if that cable is broken. If you find a broken cable, replace it, if not you may have a serious transmission problem.
How do you open a hood with a broken cable on a 1995 Chevy van?
To open the hood of a 1995 Chevy van with a broken cable, you can try accessing the latch manually. Use a flathead screwdriver or similar tool to pry open the hood release mechanism located near the front grille. Alternatively, you can also reach under the front of the van and feel for the latch itself, pulling it directly to release the hood. If these methods don't work, consider using a pair of pliers on the cable if any part is still accessible.
