0
What else can I help you with?
What is broken on 1998 Oldsmobile silhouette when gearshift will no move out of neutral?
Shift cable
How do you fix the cable for the hatch release on a 92 Blazer S10?
It depends on where its broke at. Is the cable broken at the mechanical part or is it broken before that?
How do you open trunk when cable release is broken?
With a key or from the inside.
What do you need to look for to find out why the speed odometer doesn't work on a 99 Oldsmobile intrigue?
Check the cable from the transmission, probably broken.
How do you release the parking brake if the release cord is broken on a 1988 Oldsmobile Cutlass?
If you can't access the release lever on the brake pedal (where cable connects to emergency brake mechanism), you may have to go under vehicle and access the adjusting nut (where main cable from interior of vehicle connects to the individual wheel cables) and disconnect the main from wheel cables.
Broken hood release cable town and country?
Hood release cable has connector nuts on both ends of the cable. Loosen the connector nuts. Remove the cable retainers. The cable will come off and can be replaced with a new hood release cable.
96 Oldsmobile achieva parking brake adjustment?
According to Chilton's car repair manual, the parking brake on the '96 achieva adjusts itself each time you put on the parking brake. When it does not work properly anymore, you have to change the entire cable. I have purchased a cable through my local GM parts dealer but have not yet put the cable on. It looks relative straight forward. A good Chilton's or Haynes repair manual tells alot. Martin Wilson (mcwilson60@knology.net)
How do you release the emergency brake if the cable is broke on a 1992 Chevy s10 it is the one you push with your foot?
It depends which cable is broken. If the main cable is broken under the truck, the brakes should release on their own. If the brakes dont release, the cables are frozen from rust and need to be replaced. If the release cable from the handle to pedal assemdly is broken reach under the dash above the pedal and find the small release arm. Pull the arm toward you [ the rear of vehicle ] and the emergency brake pedal will release.
How to replace engine coolant temperature sensor on 1998 Oldsmobile Achieva?
To replace the engine coolant temperature sensor on a 1998 Oldsmobile Achieva, first, ensure the engine is cool and disconnect the negative battery cable. Locate the sensor, which is typically found near the thermostat housing or cylinder head. Unplug the electrical connector, remove the old sensor using a socket or wrench, and install the new sensor after applying a small amount of thread sealant if required. Finally, reconnect the electrical connector and the battery cable, and check for leaks or any issues.
How do you open hood of ford ranger when release cable is broke?
grab the broken end of the cable with vice grips and pull it
How do you open the hood when the inside hood release is broken on a 1990 Oldsmobile Cutlass Supreme?
On my 1988 Cutlass Supreme the cable broke at the release point in the car. I was unable to see anything from the outside so in the passenger compartment I took the release handle apart and used a set up pliers to pull the cable and release the hood. There should be just on bolt holding the release in place, it may be covered by the carpet. If it can't be done from the inside you can also reach up from under the front bumper and find the cable where it attaches to the latch. Just pull the cable and the hood should release.
How do you open the hood with cable broken located on a Oldsmobile Omega?
With a long ty-rap or 2 of them one around the lever and the otherone through it to form a handle.
