answersLogoWhite

0


Best Answer

jumper wire between a&b terminal on your aldl conector. turn ignition on and watch your chech engine light, this will flash once and then twice. this is the #12 and means that system is working okay. It will flash this 3 times and then it will start flashing trouble codes. IF YOU HAVE AN ADVANCE AUTO PARTS STORE LOCATED BY YOU, YOU CAN GO AND THEY HAVE A MACHINE THAT THEY CAN USE TO PULL CODES FROM YOUR CAR AND IT IS 100% FREE OF CHARGE TO GET DONE.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How can you read the codes for a 1986 Cutlass without hooking it up to a Dianostic Machine you know there is a way to short across two of the terminals and get the reading but can't figure it out?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why has Heater stopped working Kia Sedona?

The same thing happened to me! one day i was cleaning the battery terminals and after hooking the battery back up it worked again!


What is the difference from hooking-up and a relationship?

Hooking up is just physical and a relationship is emotional and physical.


What is hooking in hockey?

Hooking is when a player pulls the opponent back with their stick by hooking it around them. However, if the opponent falls over, it may be considered tripping.


Is Robert from making the band hooking up the d.woods?

heck no they not hooking up you got him bent.


What is inline hooking?

Inline Hooking , is aprogrammaticway to change a application , function or even a entire Operating System behavior. Inline hooking is mostly used in Anti-Viruses , and Malware , such as Root-kits. Inline hooking is a very powerful technique during debugging or finding information about poorly documented functions.Inline Hooking and such require very technicalknowledge, about memory management and other low level OS functions. In each OS the Inline hooking ways differ.Regards,


What are the ratings and certificates for Hooking Up - 2004?

Hooking Up - 2004 is rated/received certificates of: USA:TV-14


What is the main rug hooking system?

There is one main way to perform rug hooking. It involves using a canvas, which shows the pattern of your rug, a special hooking tool and some yarn. There are many patterns to choose from.


How do you tell if your starter is dead?

What I do to test the starter with out taking it out of the rig is run power directly do the starter and by pass all the electronics. sometimes that can be as easy as taking a screwdriver and jumping the terminals directly on the starter. Or taking jumper cables and hooking it up to the battery if the started responds then you know!!!! happy Motoring


What would cause a 1995 dodge ram 3500 van have weak spark when warm?

A bad coil, improper rotor air gap, or corroded spark plug wires or terminals could cause this. Try hooking it up to a lab scope, it will give you more information on exactly what is happening.


How do you check an uninstalled used dishwasher?

There is no effective way to check it without hooking up water and electricity.There is no effective way to check it without hooking up water and electricity.


What happens when hooking 2 9 volt batteries together?

Interconnecting Two 9 Volt BatteriesWhat happens "when hooking 2 9 volt batteries together" depends on HOW they are connected together. IF you connect the Negative terminals together, AND the Positive terminals together, then nothing happens other than creating a 9 volt battery capable of providing twice the current [measured in Milliamps (mA), or Amps (A)].On the other hand, IF the batteries are connected with the Positive terminals to the Negative terminals of the other, THEN you will have created a very serious and possibly hazardous condition!!!!!When connected in this manner, the full current of both batteries flows, basically a full short circuit condition, and both batteries will very quickly heat up to the point of self destruction, and very likely to explode.Even it they do not explode, they will certainly become hot enough to severely burn you, and start a fire if they are in near proximity to anything combustible.Therefore, DO NOT interconnect any batteries, with both of their Positive terminals to the other's Negative without a load [electricity using device within the the circuit] to limit the current flow.If you connect the positive terminal of one battery to the negative terminal of the other and then put the load between the remaining positive and negative terminals on each battery you then have an 18 V battery. This is connecting the batteries in series.


What rhymes with scrap-booking?

slap-hooking