The Freon is added through the low side ac port. Using a gauge and the proper type Freon, fill the system to the recommended pressure. Too low or too high Freon pressure will result in the system not operating properly.
Do you charge the Lincoln from the tank with a converter or thru the line on the 93 Lincoln
A 1993 Acura Legend requires 24 ounces of R134a refrigerant to refill the air conditioning system. This is applicable to all engine types for the 1993 Acura Legend.
The amount it will take to recharge your 1993 Toyota Camry is dependent upon how low the Freon level is. A recharge kit will come with engage that will alert you when the air conditioning Freon is at the appropriate level.
Connect the Freon bottle to the low pressure port on your air conditioning compressor. Release the Freon into the compressor. The purchase of a Freon recharge kit will make the process quite simple.
The low pressure connection for your 1993 Jeep Cherokee air conditioning system is located on the top of the air conditioning compressor. There is a low pressure connection and a high pressure connection, both should be labeled.
First you have to make sure that all of the old kind is out of the system b4 you add the new freon regulated by the government. Once you have all of that out then you just open the valve (it is located on the passenger side of the car under the hood) and add it in
Your 1993 Ford Taurus air conditioning system has a Freon capacity of 5.5 pounds. You should never overfill the air conditioning Freon.
can some tell me where the port is the 1993 lexus so I can recharge air conditioner
The 1993 Chevrolet suburban C 1500 5.7 liter engine air conditioning system has a Freon capacity of five pounds. The Freon capacity should never be exceeded.
R-134A. It's the only commercially available refrigerant approved for use in automobile air conditioning systems.
This has a r134 system after 1993 was made standand industry wide to quiet the epa issue with r12
You can find the 1993 Mitsubishi air conditioning service port on top of the air conditioning compressor. The air conditioning service port will be labeled as the low pressure port.
You will have to flush the hoses with a solvent and compressed air, install low and high side conversion fittings, evacuate the system with a vacuum pump, and then recharge the system with oil charge and R134.