answersLogoWhite
Fuel Filters
Mazda 626
Air Filters and Intake Manifolds

How can you remove and replace the short water hose located just beneath the air filter on a 1997 626 Mazda?


Top Answer
User Avatar
Wiki User
2015-07-15 19:50:50
2015-07-15 19:50:50

you cut the old hose off. size up new regular heater hose to match same length.push new hose as far as you can on the right side then bend the hose to push over the left side. make sure you put the hose clamps on before you start to put the new hose on.make sure both sides are about equal then tighten the clamps down. good luck!

Related Questions

User Avatar

The fuel filter is located in the gas tank. Remove the fuel line. Next, remove the fuel filter retaining plate. Last, remove the fuel filter and replace with a new fuel filter.

User Avatar

You have to remove the gas tank, Then remove the sending unit in the top of the tank. That will be were the fuel filter is located.

User Avatar

The transmission filter is screwed to the bottom of the transmission. You need to drain the fluid and remove the pan to access and/or replace the filter.

User Avatar

When you open the hood, there is a plastic box to the right side that says "remove to replace air filter". Do not try to pop the top off of this box as i did, instead remove the two screws holding it to the body of the vehicle. The box containing the air filter is located beneath the box you just removed. There are two clips holding the cover on the box, undo these and you will see the filter sitting vertically in the box, replace it, put the cover clips back in place and replace the plastic box that was removed first.

User Avatar

remove neg battery terminal, and the gas cap then replace the filter. Its under the vehicle towasds the gas tank


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.