answersLogoWhite

0


Best Answer

ON the 99 Cherokee Sport, There are 3 screws at the bottom to remove. Once removed, slide the bottom out to get past the stop tabs.

User Avatar

Wiki User

โˆ™ 2005-05-27 02:44:34
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How can you remove the glove box in a 1996 Jeep Cherokee Classic?
Write your answer...
Submit
Related questions

Where is the jack placement for 1996 jeep Cherokee classic?

under differential


Where is the fuel pump on a 1996 Jeep Cherokee classic?

In the fuel tank


How many liters of engine oil for jeep Cherokee classic 1996?

About 5


How do you remove driveshaft from 1996 Jeep Cherokee?

i need to remove the rear driveshafts to take out the diff from my 1996 jeep grand Cherokee auto 4.0 petrol can you help me please


What is the tapping noise coming from the glove box in your 1996 grand Cherokee?

The most likely problem is the blower motor making the noise. It may be necessary to remove the box to find the noise for sure.


1996 caprice classic?

1996 caprice can you remove 4.3 engine and install a 5.7?


How do you get glove box out of 1996 dodge Dakota?

I believe on the '96's you open the glove box and remove the screws on the top edge


Where is the crank shaft sensor for a 1996 jeep Cherokee classic?

If it is the same as my Cherokee it will be on the top of the transmission on the driver side right behind where the engine and transmission join.


How do you remove side rear window on 1996 jeep Cherokee?

throw a rock at it


Does the fuel tank have to be removed to replace fuel pump on a 1996 jeep Cherokee classic?

The fuel pump is inside of the gas tank on a 1996 Jeep Grand Cherokee so the tank must be removed in order to replace the fuel pump. I'm pretty sure its the same for the Cherokee "classic". I just had mine replaced a few months ago. Good Luck!


How do you remove the belt in order to remove the alternator in a 1996 Jeep Cherokee?

The ajustment bolt for the belt is under the power steering pump.


How do you replace a 1996 Chevy capric classic bumper?

Remove the bumper and put on a new one :)


Where is the flasher on a 1996 dodge ram 2500 van?

the flashers in the 1995 - 2500 ram van are located behind the glove box - have to remove inside of glove box to see them.


How do you replace a heater blower in a 1996 mercury villager?

Open the glove compartment and remove it. Disconnect the electrical connector and the three mounting screws. Remove motor.


How do i change the fuel pump on a 1996 caprice classic?

Located in the fuel tank - may have to remove for access remove tank?


How do you remove a radio from a 1996 Jeep Cherokee 2.5L?

I assume it's very similar to my 95 cherokee. I've posted instructions (with pictures) for replacing the radio at www.timsjeepblog.com.


Do you have to remove the tire to replace a fuel filter on a 1996 Jeep Grand Cherokee?

Not if you can get far enough under to access.


What rear axle does the 1996 jeep Cherokee classic have?

If it's automatic, it is most likely a non ABS Chrysler 8.25 axle with 3.55 gears.


How do you unlock glove box 1996 Jeep Grand Cherokee?

You should be able to use the key that is used to start the car. Place the key inside the key slot that is in the front of the glove box and turn counter-clock-wise, this should unlock it!


Where is the front heater blower motor on a 1996 Mercury Villager?

Remove the glove box. The front blower motor and the resistor can be accessed from there.


Where is the radiator drain plug for a 1996 Jeep Cherokee?

Should be on the bottom or rear of radiator or remove lower radiator hose


When was The Cherokee Kid created?

The Cherokee Kid was created in 1996.


Where is the ecm on a 1996 olds ciera?

It is located directly on the firewall behind the glove box. It is easier to remove with less chance of damaging the ecm holder if you remove the screws on the front of the glove box, the screw holding the glove box retaining cable, and the bottom screws holding up the bottom cover just below the glove box. This will be easy since all of the screws are 7mm screws. The screws that hold the pins onto the ecm are also 7mm. You will then remove the ecm from the bottom but by taking the glove box out you can actually see what you are doing.


How do you remove the ignition key that is stuck in a 1996 Jeep Cherokee Sport?

put it into park, i made the same mistake and couldn't get it out for ages!


Wiper relay location 1996 Jeep Cherokee?

Where is the windshield wiper relay located on a 1996 grand jeep Cherokee