answersLogoWhite

0

To lower the glove box. There are two black plastic stop tabs sticking up past the back wall of the glove box, these stop tabs hit against rubber stops and keep the glove box from falling open. Fold these rubber pieces to the side to let the black stop tabs go by. (They are attached to the dash only on one side so as to act as a hinge point) The rubber stop on the left, is about an inch to the left of the glove box light switch. The right rubber stop is about eight inches to the right of the light switch. Remove the dampener arm on the right side of the glove box by sliding the end, up and out of a key slot type of hole. The glove box should be hanging down at this point.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the fuel pump on a 1996 Jeep Cherokee classic?

In the fuel tank


How many liters of engine oil for jeep Cherokee classic 1996?

About 5


What is the tapping noise coming from the glove box in your 1996 grand Cherokee?

The most likely problem is the blower motor making the noise. It may be necessary to remove the box to find the noise for sure.


How do you remove the upper glove box 1996 odyssey?

To remove the upper glove box on a 1996 Honda Odyssey, first open the glove box and locate the screws securing it to the dashboard. Remove these screws using a screwdriver. Next, gently pull the glove box forward to release any clips or tabs holding it in place. Once free, you can lift it out completely.


1996 caprice classic?

1996 caprice can you remove 4.3 engine and install a 5.7?


How do you remove the glove box on a 1996 peugeot 106?

To remove the glove box on a 1996 Peugeot 106, first, open the glove box and locate the screws securing it to the dashboard. Remove these screws, typically found on the top and sides of the glove box. Next, gently pull the glove box towards you; it may be necessary to unclip any retaining clips at the bottom. Once free, disconnect any wiring if applicable, and the glove box can be completely removed.


Where is the crank shaft sensor for a 1996 jeep Cherokee classic?

If it is the same as my Cherokee it will be on the top of the transmission on the driver side right behind where the engine and transmission join.


How do you get glove box out of 1996 dodge Dakota?

I believe on the '96's you open the glove box and remove the screws on the top edge


How do you remove side rear window on 1996 jeep Cherokee?

throw a rock at it


Does the fuel tank have to be removed to replace fuel pump on a 1996 jeep Cherokee classic?

The fuel pump is inside of the gas tank on a 1996 Jeep Grand Cherokee so the tank must be removed in order to replace the fuel pump. I'm pretty sure its the same for the Cherokee "classic". I just had mine replaced a few months ago. Good Luck!


How do you remove the glove box in a 1996 Mercury Villager van?

To remove the glove box in a 1996 Mercury Villager van, first, open the glove box and locate the hinges on the sides. Carefully unclip or unscrew these hinges to detach the glove box from the dashboard. Additionally, you may need to remove any screws securing the lower part of the glove box or disconnect any wiring for lights if applicable. Once everything is unfastened, gently pull the glove box out to complete the removal process.


How do you remove the belt in order to remove the alternator in a 1996 Jeep Cherokee?

The ajustment bolt for the belt is under the power steering pump.