If a motor is designed to run on different voltages there will be a wiring diagram on motor plate for 120 volt wiring. If not you will have to use a step up transformer to convert 120 V to the higher voltage.
No, you will need a commercial mixer for that.
The voltage of 120 volts is more common that the lower voltage of 12 volts.
In Europe 240 volts is standard, so no a 115 volt motor will not work. In USA 120 volts is standard, so if your sub-panel has 120 volts, (check with voltage meter) then yes. Read carefully, To get 240 volts in a sub-panel in USA the electric company brings two (2) wires, each wire has 120 volts, 120 + 120 = 240. One of those 120 volts will run your motor. Look for the wires from the electric company and check them with your voltage meter. If this is a commercial application you will need to call an electrical contractor, power companies for commercial applications do not follow the above.
It is possible to check the resistance of the motor leads compared to a known motor. You can also connect the leads to 120 volts temporarily. If the motor hums and runs slowly or not at all it is a 220 volt motor. If it runs normally, then it is a 120 volt motor. Testing should be done for only a few seconds so if the motor is designed to be run on 220 volts, you don't overheat or damage it on 120 volts.AnswerRead the nameplate information.
You don't. A ballast with a 347 volt input is a commercial ballast. The 347 volts comes from a 600 volt three phase four wire Y system. You can change the ballast out to a 120 volt and rewire the unit but in most cases it is cheaper to buy a completely new lighting fixture.
Because it is a 220 volt outlet instead of a 120 volt outlet. Now, if this is a standard 120 volt outlet that is reading 209 volts then someone has made a mistake in the wiring. You need to call an electrician to straighten this out.
120 volts.
Yes. Circuits in a home are 120 volts but people tend to call them 110 volt circuits. The 120 volts you read on the appliance is the maximum voltage the appliance can handle. The actual voltage you will read at any outlet will range from 110 to 120 volts.
12 Volts DC
One has an element designed to work on 120 volts, the other has an element designed to work on 240 volts.
120 volts 60 hz
120 volts