Want this question answered?
Hit it with a sledge hammer.
Term used with cast-iron, PVC, CPVC and ABS pipe. Cast-Iron; The plain end of a cast-iron pipe. The spigot is inserted into the bell end of the next pipe to make a water tight joint. PVC, CPVC or ABS; A male end of a fitting the same size as the pipe that is inserted into the slip (hub) end of a fitting.
Loosen the clamps and use some elbow grease to twist the fitting into the desired position.
Malleable cannot be broken like a cast fitting can be and normally malleable fittings / pipe do not have a seam +++ Its full name is Malleable CAST Iron - it is cast as "ordinary" cast-iron but is a lot less brittle. It is an important material combining some of the properties of cast-iron with those of mild-steel.
When I have to connect copper to lead "D" I usually solder the copper to the lead or wipe a lead joint depending on the diameter To connect copper to cast iron ,.... If there is a hub I caulk the copper directly into the CI with oakum and poured lead (molten) OR one can solder / braze a female adapter fitting and screw the copper into a CI female fitting
Cast iron is not threaded, steel pipe is.
was asbestos used in production of cast iron pipe
MIP ==> Male Iron Pipe thread (i.e. threads on outside of fitting) FIP ==> Female Iron Pipe thread (i.e. threads on inside of fitting)
Asbestos pipe is made of cement that contains asbestos fibers. Iron pipe is made from cast iron.
American Cast Iron Pipe Company was created in 1905.
American Cast Iron Pipe Company's population is 3,000.
You use a 'Robar' fitting, which is essentially a rubber sleeve with large hose clamps to tighten it.