Take the vehicle to a qualified alignment shop, they will be able to tell you if your control arm is bent.
Which ever one you think may be bent, Just take it out and roll it on a flat surface. If it is bent bad you will have a engine miss on that cylinder.
It would be wise to replace the bent part with a new or good used one.
As far as I know nobody makes bushings for front control arms of Altima 93-01. Many Internet stores sells complete control arms with bushings and bell joint. I've found one that sells at 79$.
One lower control arm for each front strut.
The power that Congress is allowed to control is the second amendment of the Bill of Rights, the right to bear arms.
a bent control arm will change alignment angles. This can result in poor tire wear, a pulling to one side, tire rubbing on wheel well, etc... Basically its not good and not safe, get it replaced
ah bent axle housing? broken/bent shafts? if it's a D35c i'd check the shafts, also check your control arms, upper and lower, your trackbar... and i'd also get an alignment if the problem isn't solved
They would be connected to two control arms, one upper control arm and one lower control arm.
The power that Congress is allowed to control is the second amendment of the Bill of Rights, the right to bear arms.
Muppets are operated puppets operated by Muppateers. They are controlled by a person underneath them who uses one hand to control the face and another to control the arms.
The power that Congress is allowed to control is the second amendment of the Bill of Rights, the right to bear arms.
It is located on the right side of the engine above one of the control arms.