answersLogoWhite

0

right rear of engine (looking at engine from front) where speedometer cable goes into front of transmission, remove retainer bolt and ubscrew speedometer unit, on side of unit is a small lever gauge. fill thru that hole.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What are step by step instructions to replace drum brake pads on a 1991 Ford Festiva?

Get a manual from DISCOUNTAUTOREPAIRMANUALS.COM for about $9


What is the transmission fluid capacity for a 1989 Ford Festiva?

The transmission fluid capacity on a Ford Festiva is 3.75 litres for a manual transmission.


Where is the transmission dipstick located on the 1991 Ford Festiva?

I am guessing that this is a manual shift . It has no actual stick . You must take the speedo cable housing loose at the trans , 10mm bolt and pull it up , the fluid level check is on the end of that assy. very easy to do .


How do you replace the clutch in a 1991 Ford Festiva?

very carefully.


What type of motor oil in 1991 Ford Festiva?

5w-30


What is the valve clearance supposed to be on a 1991 Ford Festiva?

you can not adjust.does it byself


What is the motor Oil capacity 89 Ford Festiva?

My 1989 festiva owner manual states: 3.9 quarts with a filter change.


What gearbox oil should you use for a 2000 Ford Festiva WF?

I think the Festiva manual transmission uses ATF The auto parts store or the owners manual will tell you


Where is the transmission dip stick located in a 1989 Ford Festiva located?

On the manual trans there is no dipstick.You check level by marks on speedo gear in transaxle which you remove by removing one 8mm bolt on drivers side of trans axle.It uses Mercon V automatic trans fluid.


Oil capacity for 1991 Ford Festiva?

3.6 Quarts (including filter)


What Type of transmission fluid used in 97 festiva?

Ford did not make a festiva for sale in the us in 1997. They made and sold an Aspire auto trans or straight drive


Where do you top up gearbox in a manual Ford Festiva 1992 i was told it was through the speedo caple hole but doesnt seem right as the hole is very small and no flow?

The speedo hole is where you do it. Read the manual! Remove the 10mm bolt holding the speedo sending unit in the trans and there is a nice big hole for you to fill the trans.