0
What else can I help you with?
Why does the switch between Host and the router not require configuration with an IP address to forward packets?
If a switch is connected to a router then the MAC address of the router is known to the switch through that port. A host takes advantage of this by using the default gateway address (the address of the router) which the switch "knows" by its lookup table. Therefore, the switch can learn the address automatically and no configuration is necessary.
What is different between router and switch?
What is diffrent between router and switch?
Explain the difference between user EXEC and privileged EXEC modes?
Privileged mode has access to the entire router or switch configuration. User EXEC mode only has limited options. Specifically, to do any configuration changes, you need to enter privileged mode first.Privileged mode has access to the entire router or switch configuration. User EXEC mode only has limited options. Specifically, to do any configuration changes, you need to enter privileged mode first.Privileged mode has access to the entire router or switch configuration. User EXEC mode only has limited options. Specifically, to do any configuration changes, you need to enter privileged mode first.Privileged mode has access to the entire router or switch configuration. User EXEC mode only has limited options. Specifically, to do any configuration changes, you need to enter privileged mode first.
Why we use straight cable to connect between the router and switch?
we use straight cable to connect between the router and switch as router and switch are different devices.
What is the function of an NVRAM in a router?
The NVRAM is the primary place a router or switch stores the configuration file which tells the device how to operate.
Is config t a mode in router configuration?
Yes, Config t stands for configure terminal. This command is to switch into configuration mode .
Which names correctly identify the CLI mode represented by the prompt for Switch-East4?
line configuration mode user executive mode * global configuration mode privileged executive mode interface configuration mode * enable mode8 What command is used to change the default router name to Fontana? Router# name Fontana Router# hostname Fontana Router(config)# name Fontana * Router(config)# hostname Fontan
What is setup mode?
When a Cisco router is booted up for the first time, or is reloaded, the router will look into its Non-Volatile RAM (NVRAM) for the startup configuration file. Setup Mode is usedto configure a Cisco router or switch after start up to create a startup configuration file.
What is difference between L3 switch and router?
A layer 3 switch has routing capability like a router. However, it also has layer 2 switching capabilities like a switch. To fulfill both functions, layer 3 switches will generally have a greater number of ports than most routers.
Which of the following devices separates collision domains?
Network+ Guide to Networks answer: Bridge, Switch, Router
What Cable configuration used in PC to router connection?
Use a straight through cable, just as you would with a hub or switch.
Maintaining records of the versions of the operating systems installed on every switch and router in your organization is part of what recommended practice?
Configuration management
