0
1: Make sure you get the right replacement light
2: Remove keys from ignition
3: Make sure lights are off
4: Open hood to vehicle
5: Locate the secure ring that is holding the light in place. Should be surrounded by a rubber membrane
6: Rotate the ring counter clockwise. This may take some muscle especially if it has been replaced before. It is a tight area to work but keep at it till the ring turns
7: Once the ring is unsecure pull the light straight back out of the headlamp. Again your working in a tight area.
8: Now come the difficult part. There is a white secure locking tab and a blick knuckle you can see thru the middle. Most tutorials say push down on the white tab and pull light out. WRONG!! The white tab will not release the bulb. Instead put on a pair of gloves cause your about to bust a knuckle or hurt your hand. Take a smaill flat head screa driver and wege it between the knuckle and the white secure tab. This takes great care and strength but can be done. But chances are your gonna hurt your hand a few times doing this. You should now have the flat part of the screw driver seperating the black knuckle from the white locking tab that many say push down on.
9: Now your about to bust your hand again. While pulling like hell on the white part, pull on the bulb..Keep pulling. The socket is probably dirty and really doesn't want to let the bulb come out.
10: Cuss
11: Keep pulling
12: Take a break
13: Try again
14: Cuss and threaten the car
15: Get a band aid
16: Finally get bulb out of socket and watch secure ring fly through the air. Cuss more
17: Be sure to be wearing gloves before touching new bulb. Oil from your hand will cause bulb to burst when turned on. Put secure ring back on making sure it is facing the right way and place new bulb in aligning the black knuckle to the secure locking tab.
18: Should hear it click. Test and make sure light works.
19: Line up light bulb with secure tab on top (very important)
20: Spin the secure locking tab till it lines up. You know when cause it will seat in further
21: Secure locking ring by turning it clock wise
22: Threaten car again
23: Have a beer
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you change the transmission fluid on a 1995 Isuzu trooper 4x4?
How do you change the transmission fluid on a 2001 4x4 Isuzu trooper
How do you open hood of Isuzu Trooper 2001 if latch is broken?
how to get a 2001 isuzu trooper hood open if release cable is broken
How many catalytic converters does a 2001 Isuzu trooper have?
Look under the Trooper and count them.
Where is the oxygen sensor on a 2001 Isuzu Trooper?
on the exhaust manifold.
Will a 1999 Isuzu Rodeo headlight work on a 2001 Isuzu Rodeo?
Yes
Does the 2001 Isuzu trooper need a bypass key to install a remote starter?
bypass key on a trooper
What car does a Fram CA7417 air filter fit?
According to rockauto: HONDA PASSPORT EX (1994 - 2002) HONDA PASSPORT LX (1994 - 2002) ISUZU AMIGO (1998 - 2000) ISUZU AXIOM (2002 - 2004) ISUZU RODEO (1993 - 2004) ISUZU RODEO SPORT (2001 - 2003) ISUZU TROOPER (1998 - 2002) ISUZU TROOPER LS (1992 - 1997) ISUZU TROOPER LTD 1997 ISUZU TROOPER RS (1993 - 1995) ISUZU TROOPER S (1992 - 1997) ISUZU TROOPER SE 1996 ISUZU VEHICROSS (1999 - 2001) TOYOTA T100 (1993 - 1998) TOYOTA T100 DLX 1995 TOYOTA T100 DLX EXC 1995 TOYOTA T100 ONE-TON 1993 TOYOTA T100 ONE-TON DLX 1995 TOYOTA T100 SR5 (1993 - 1997)
Where is the thermostat on a 2001 3.5 Isuzu Trooper do you have a diagram of it?
Under the intake mannifold (you have to remove it to get to it).
What is the freon capacity of a 2001 Isuzu trooper?
1.65 pounds. It's on the sticker on the driver's side of the firewall.
Where the fuel pump are locate in a 2001 Isuzu trooper?
It's in the fuel tank, like on all modern vehicles.
Gas mileage for a 2001 Isuzu trooper?
My 1999 Trooper gets about 16 MPG with mixed highway and city driving. I believe that it has the same drive train as the 2001. If I drive at moderate speeds on the highway, I can get 19 MPG.
Where is the fuel filter located on a 2001 Isuzu Trooper?
The fuel filter is located near the right rear wheel bolted to the chasis.
