Replace the front seal on the pump
Brake switch....open or shorted...could even be water causing a short.
The 1987 Nissan Maxima VG30E engine uses hydraulic valve adjusters (also known as "cam followers") which cannot be adjusted. Therefore, there is no specific valve clearance. If you hear valve noise, it could indicate that there's either excessive wear of valve train parts or clogged hydraulic adjusters.
There isn't a 'forklift license' in the US. Some companies may issue a forklift certification which potentially could expire.
A list of Preventive Maintenance Task for a Hydraulic System could be: Change the (could be the return or pressure filter) hydraulic filter. Obtain a hydraulic fluid sample. Filter hydraulic fluid. Check hydraulic actuators. Clean the inside of a hydraulic reservoir. Clean the outside of a hydraulic reservoir.
One may look into getting the repair done by a professional for a hydraulic pallet jack. Sometimes jacks are too old to be repaired and need to be replaced. There is a great danger in using a faulty hydraulic pallet jack that could cause sever injuries.
You can go to an certified institution such as local college to get forklift certification in Florida
Sounds like you have too much fluid in the system. Or the sump could have a buildup of silt or other detritus in it that needs to be cleaned out. Drain the sump, clean the sump, then replace the recommended fluid into the sump. Make sure the cylinder(s) is fully retracted when you do this.
A loss of hydraulic fluid can cause a serious situation with the mast. It would cause the mast to lower slowly or suddenly. Also if there is a break in the chain that holds the mast at a certain level, it would cause it to fall suddenly.To reduce the pressure in the fuel line , the forklift operator should
Then you'll have excessive hydraulic pressure, and could damage the hydraulic system.
Your best bet for getting a forklift license in the Fort Smith, AR area is to find a job that will train you and certify you in that field. I have done a lot of searching and could not find a place in your area that will just train you for a forklift without you working there. One great place you may try for a job and the license is at http://www.glassdoor.com/Job/fort-smith-forklift-driver-jobs-SRCH_IL.0,10_IC1143091_KO11,26.htm
I need a list of forklift classes or training in the chicago area for a individual cerfication If you have some experience on driving a forklift, we could complete the entire process on line by going to Forklift Academy .com
red