To bypass the rear window switch on a Bronco, you can access the wiring harness connected to the switch and locate the power and ground wires. By connecting the power wire directly to the window motor, you can activate the window without using the switch. Ensure that you take proper safety precautions to avoid any electrical shorts, and consider reconnecting the switch or replacing it for a permanent fix. Always consult a wiring diagram specific to your model for accurate identification of wires.
jeff's bronco graveyard.com
In a 1988 Ford Bronco, the switch to roll down the back window is typically located on the driver's side door panel. It may be a toggle switch or a push-button switch, often positioned near the controls for the front windows. If the Bronco has power windows, there might also be a separate switch for the rear window on the rear door or center console, depending on the specific model configuration.
To remove the rear window switch on a 1995 Ford Bronco, first, ensure the vehicle is off and disconnect the battery for safety. Use a flathead screwdriver to gently pry off the switch panel from the door trim. Once the panel is removed, you can access the switch; disconnect the wiring harness by pressing the release tab and pulling it out. Finally, you can unscrew the switch from its mounting to complete the removal.
I have a 91 bronco and I've had problems myself with the rear window. First check the fuse panel to see if the fuse for the rear window is blown. I believe its a 20 amp. Also if the interior switch and the key switch on the tailgate both dont work, try pushing in on the tailgate while trying to move the window down or up
To fix the rear window on a 1995 Eddie Bauer Bronco, first, check the window motor and switch for functionality. If the motor is faulty, it may need to be replaced. Inspect the window track for any obstructions or damage; clean or repair as necessary. If the wiring is damaged, repair or replace it to ensure proper operation.
To remove the rear tailgate window switch on a 1995 Ford Bronco, first, disconnect the vehicle's battery to ensure safety. Then, use a flathead screwdriver or a trim tool to gently pry off the switch cover from the tailgate panel. After removing the cover, you can access the switch's mounting screws; unscrew them and carefully pull out the switch from its housing. Finally, disconnect the electrical connector from the back of the switch to complete the removal.
check your tailgate switch on the dash mine went bad and after i replaced it it was like new
You can find a rear window dash switch for a 1993 Ford Bronco at several places. Check local auto parts stores, as they often carry replacement parts for older vehicles. Online retailers like eBay, Amazon, or specialty sites that focus on classic Ford parts may also have the switch. Additionally, a salvage yard might have a compatible switch from a similar model.
Turning the window crank in a counter clockwise direction, the window will go down, reverse direction to raise it. If you are speaking of the rear window the switch is on the a/c control panel. Down makes the window go down and up is up
To remove the window in the rear hatch of a 1989 Ford Bronco, the weather stripping around the window will have to be pulled back or pushed down slightly. This can be accomplished with a straight screwdriver or a putty knife.
On a ( 2000 ) Lincoln Navigator the rear window defroster switch is located in the dash below the headlight switch
If its the bronco XLT you'll have to take the tail gate paneling off the inside. The motor, gears, etc. for the rear window are located in there. I had the same problem with mine sometime back.