How do I Remove spare tire from 1995 Tahoe?

Answer 1

Take your car key and open the little hatch on the middle of the back bumper, insert your key and unlock the crank lock. Tehn take your jack extension handle and slip it in the hole until it connects with cable lowering system. Turn to the left to lower the tire to the ground. If yours is like mine, the cable will extend but somehow the tire won't come down. If its not like mine, the fishtail is passed through the hole in the rim to get it off the cable. Good Luck, Sandman

Answer 2

In with the jack tools the hex shaped tool with one flat side (we will call this Tool A for the purpose of these instructions), and one end that looks like a socket (used to remove your lugnuts) there is also a tool that looks like one of the newer ratcheting box wrenches(we will call this Tool B for the purpose of these instructions). 1. Slip the ratchet (Tool B) over the end of the hex tool (Tool A) with the notation on the ratchet showing "down" towards the socket end of Tool A. 2. Slip the flat side of Tool A into the round hole to the right of your rear license plate as far as it will go and begin to turn the ratchet A. The spare is on a cable winch under the truck and will begin to lower B. I suggest waiting until the spare reaches the ground, and you begin to see some slack in the line before proceeding 3. You should be able to see the end of the cable, and the bar it is attached to in the center of the spare, move it to one direction, angle the end of the bar through the center of the wheel, and remove. 4. To put the spare back up, reverse the direction of the ratchet (Tool B) so that it reads "up" towards the socket end of Tool A, reinsert to the hole in your bumper to the right of the license plate, and draw the winch up.

Answer 3

Read the manual. It will tell you.

Answer 4

read the owner's manual