Turn off alarm with ignition key in the driver's door.
To turn off the car alarm on an Acura use your key to unlock the driver side door.
Pushing the button on your remote....
use key to lock the car, that turned off my 2003 Acura MDX
its probably the main relay that needs to be replaced
You more than likely have a blown fuse. Check the fuse for the radio.
this is your safety switch alarm sensor located below the steering wheel left hand to you it is a push button that will turn off your automatic locking system and turn it on at your request.
it can be lost of Compression in the Motor....
Good day: I have pulled the front shroud off of my 95 acura legend again. Now I have no turn signals (front or rear). I cannot seem to locate the flasher with on line pictures. CAN YOU HELP ME WITH IDEAS OF BETTER PICTURE OF FLASHER LOCATION?
The OEM factory alarm systems have a procedure that is used to reset the alarm. To do so, turn the key to on position and press the lock/unlock button. Do this three times in five seconds and the alarm with be in program mode. Here the alarm can be reset.
To reset the alarm on a Corolla 1993, place they key in the ignition and turn it until it clicks. Keep the key in this position for 10 minutes and then start the car as normal.
Honda factory alarm systems use a program function. To program the alarm turn the car into the on position and press the lock button. Do this three times in five seconds. Once in program mode and the alarm can be disabled.
It would be your ignition lock not cathing and needs to be replaced. I have 90 acura legend L. Problem is bad ignition switch. They are about $70 at autozone.