0
How do I access BOTH bolts holding in place the 100 Amp main fuse on a 1998 Ford Escort?
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What eye bolts are used for?
Eye bolts are commonly used to attach cables to objects for lifting or holding in place
How do you change filter and fluid in transmission on a 02 cavalier?
Remove the bolts holding the transmission pan in place and the fluid will come out and you can access the filter. The filter should pull right out and the ne2w one just presses back into place.
How do you replace a serpentine tensioner on a 1997 Saturn SC1?
Remove the Right wheel and inner plastic fender which will allow you access to the tensioner side of the motor. There will be a few bolts holding into place on the block. Remove the bolts and remove the entire tensioner assembly. Reverse for replacement.
Why would a fiat punto door creak and rub on the wing?
the wing is out of place. lift the bonnet and loosen the bolts holding it , check around the wing for any other bolts holding it in place. you should be able to pull it forward a little with your bare hands. then tighten the bolts. voila! i had to do this to my own car and it was such a breeze.
How do you replace the taillights on a 2000 golf?
There's a lot to explain, but you have to access the bolts from the rear of the car where the CD changer is located, there's like 3 or 4 bolts hold it in place on the driver side, on the left there's a panel you remove opposite the CD changer, access these bolts, when you pull it out, go outward left or right depending on the taillight, then back or you will break the lower side since there is a screw holding it in place... bottoms line be careful, and check the forums...
How do you remove the steering wheel on a 1971 VW super Beetle?
first take of the cover if you have one it will be round or a sideways H, take out the bolts that are holding the horn on, then take the bolts out that are holding the steering wheel in place.
How do you remove Avalon front seat motor?
ermove the bolts holding the seat down. unplug wires going to seat. turn seat over. remove bolts holding motor in place. reverse prcess to install
How do you find the thermostat in a subaru 2004 impreza wrx supercharged?
it is located at the engine side of the bottom radiator hose . There should be two ten mill bolts holding it in place . Just remove the under tray for easy access
How do you remove Citroen Xsara dashboard?
Remove long piece of trim which will then allow you access to the fixing bolts. Remove these bolts and the belt will come out
Having problems disconnecting starter on 1996 Buick Century any hints?
Some GM starters use a washer that makes it very difficult to remove unless you hold the back side of the bolt. Disconnect the positive battery cable and make sure it will not contact the positive battery post. Now remove the bolts holding the starter in place. This will allow you to get the starter in a position where you can easily access the bolts holding the wires in place. Be careful and do not damage the wiring.
How do you take out the dash step by step from an 84 CJ7?
I got the answer from another site: 4 screws on the inside/bottom of dash; put front windshield down, which gives access to the remaining screws/bolts holding the dash in place. Presto!
Where is the Starter for a 2002 Ford Escort?
The starter is located between the engine and the firewall towards the bottom. There are 3 bolts that hold it in place. zx2 2002 model.
