To change the garage door light bulb you need to remove the protective casing. Once you have removed the positive casing, you can replace it with a new one.
there are many light bulbs on the Honda accord.. what light bulb?
I have to know the amps and voltage of the garage door motor and the length of time the door takes to open and close to answer this question.
What type of light problem?
You must first remove the trunk door facia. (This is the part with the "Pontiac" lights in it.) Then you can get to the bulb to replace it.
My garage door openers have labels on them saying MAXIMUM 75 watts so I don't think so , but it would depend on the opener ( I use a 60 watt bulb in mine )
Linear garage door openers are used for opening a garage door in a wireless manner. They use a light beam and receiver to allow one to open the door without physically touching it.
Press the button that will be used for the door opener until the light starts flashing. Then hold up your garage door opener remote and press to open garage door. It will then set.
AnswerDepends on the garage door opener you have. For the most part hold the button on the visor until it flashes fast, or slow, Just so you see the light change. Then hold the button on you garage door remote next to the visor until the light on the visor changes again. This should do it. Now if you have a rolling code garage door opener then you need to locate the learn button on the garage door opener motor. Press the learn button until it changes and then run to your car and press the visor button until you see the light on the garage motor hold steady. Good luck.Also, try www.homelink.com
The built in garage door buttons run off of the cars battery.
Garage door sensors use infrared light. The sun also carries infrared light which, you guessed it, is more powerful than the light of the sensors. If the light of the sun surpasses the infrared sensors light, the sensors might not be able to signal one another. This is why a garage door might stop closing if strong sunlight is shining on the eye of a garage door sensor. For more call us at 678-487-2727
Just press the red button on your garage lifter, and when the light flashes press and hold the button in your your car until the light flashes again or the garage door moves.
Your garage door and your neighbors transmitter are on the same frequency. You will probably need to change one of the frequencies.