You will need 2 wrenches turning in opposite directions on the retaining nut - its not vey complicated.
i like look for total trimmer blade
There are three steps on how to put the blades for a beard trimmer back together. The step-by-step instructions are face the clippers with the blade angled down, push on the trimmer blade from the back of the trimmer, and then slide the new trimmers on the same way that the old ones came off, but only in reverse.
On my Craftsman Lawn Mower, I have to raise the lawn mower or tilt it on it's side, and underneath where the blade is, there is a large drain plug. Take it off and catch the oil. This is a great time to clean the underside of your lawn mower and either sharpen or replace your blade.....Nothing cuts better than a sharp blade!
yes where can I buy the mulching blade
counterclockwise
What to do when your paper trimmer does not cut straight First check the paper trimmer blade. If the blade needs to be replaced the trimmer will begin to cut with rough edges and often not on a straight line. Second, if your paper trimmer has a replaceable piece underneath the blade (this is a piece that would touch the backside of the paper, where the blade would glide across as it cut through the paper), try to replace that. With time those pieces become warped and will cut crooked. Third, make sure you are lining your paper up along the grid. If all else fails, it is possible that you may need to invest in a better paper trimmer. Some popular paper trimmers that people feel cut straight edges are the Creative Memories 12" paper trimmer and the paper trimmer made by Provo Craft, called the Cutterpede.
The Wahl 8685 provides the closest shave to a blade shave that a clipper/trimmer can provide.
Most blade bolts on lawn mowers are reverse threaded. The bolts on the Craftsman brand lawn mower are also reversed.
A professional trimmer like the Andis Excell does not require much maintenance. It does not require the oiling or greasing of internal parts. Although a small brush may be needed to clean the hair off of the blade.
Sure. They have cordless trimmers that will accept a blade type of cutting head. You would be cordless and stringless then.
Install a lock washer between the head of the bolt and the flat washer that rests against the blade.
Recommended tightening torque is 35-40 ft. lbs.