Best Answer

the only way i could figure out how to get the starter out was to remove the right engine mount

User Avatar

Wiki User

βˆ™ 2007-09-30 16:08:37
This answer is:
User Avatar

Your Answer

Still have questions?

Related Questions

How do you change the sending unit on a 1986 Chevy Blazer?

Which sending unit? Oil or temperature? Or ?????

Does a 1986 Chevy s10 blazer have ignition points?


What is the towing capacity of a 1986 Chevy Blazer?

go to chuck's Chevy pages .com the answer should be there.

What is the correct Timing for a 1986 Chevy blazer with a 350?

8 to 10 degrees.

Where is the fuel filter located on a 1986 Chevy Blazer?

On the fuel line going to the carburetor.

Where is the fuel filter on a 1986 Chevy S10 blazer 4 wd Tahoe?

Under the power steering pump in front of the engine. It is not an easy one to change.

How many bolts does a starter on a 1986 Chevy Celebrity?

If it is a 2.8 it has 2

What is the latest engine that will fit in a 1986 Chevy k5 blazer?

1987 is the last year for a carburetor.

Can you change a 1986 4x4 s10 Chevy blazer to a two wheel drive?

yes you can. just take off the front driveshaft from the transfercase. there you go, 2 wheel drive.

Where is fuel pressure regulator on 1986 s-10 Chevy blazer 2.8 liter?

It is in the throttle body.

1986 Chevy s-10 blazer and it has been stalling after approximatley 10 mins of running the starter rotor distributor cap spark plugselectronic control moduel been replaced any ideas?

Did you replace the fuel filter?

Where is the starter selonoid located on a 1986 Chevy pickup?

It is mounted on the top of the starter. Just follow the positive cable from the battery and it will be bolted to the selonoid.

Where is the starter located on a 1986 Chevy Camaro 2.8liter v6?

Lower rear end of the engine

What are the tire specs on 1986 Chevy k-5 blazer?

They came with 31x10.50 R 15 Radial Tires.

How much horsepower does a 1986 Chevy k5 blazer 350 ci have?

With a 4-barrel carb. 155hp @ 4000 rpm

How do you change the starter on a 1986 Chevy Celebrity?

To change the starter motor on a Chevy Celebrity: 1 Disconnect the battery ground. Use protective gloves. 2. Set the parking brake. Raise the car as required and put on jack stands. 3. Disconnect the wires at the starter solenoid. Take note of where they come off so you can put them back on. 4. If there is a brace from the starter to the block remove it. 5. Take out the two bolts that hold the starter in place, pull the starter out of the bell housing. If there are shims between the starter and the bottom of the engine block save them for use with the replacement starter. Reverse the process to install a replacement starter.

What does starter look like on 1986 Chevy 1500?

it has 1 short bolt and 1 long bolt

What is the towing capacity of a 1984 Chevy K5 Blazer?

Here's a link to the answers most are looking for. It's a brochure for the 1986 Blazer/Suburban/Jimmy's. Looks like 6000lbs for gasoline engines, less for diesel.

Where is the starter located on a 1986 Chevy camaro v6 please be specific?

lower rear passenger side of engine

How do you change a starter on a 1986 mustang v8?

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter

Can you start out driving on 4 wheel drive high in a 1986 Chevy Silverado Blazer?

Yes you can, but don't drive over 50 to 55 MPH

What year did Chevy small block change dip stick sides?


How do you change starter on 1986 dodge omni?

Disconnect the - battery cable Lift and safely secure vehicle Remove wires from starter Remove mounting bolts Drop starter

How do you change a starter on a 1986 Oldsmobile?

Disconnect the - battery cable raise and support vehicle Disconnect wiring harness at top of starter Remove mounting bolts Remove starter

What is the firing order on a 1986 Chevy S-10?

On a 1986 Chevy Blazer S10, the firing order is: 2.5L 4 cyl engine: 1-3-4-2 2.8L V6 engine: 1-2-3-4-5-6