After selecting a location for the spa pool, it is necessary to build a base that will be strong enough to support the weight of the pool, water and occupants. It is then necessary to install an electrical connection to the pool. At this point, the pool will need to be filled with water and chemicals must be added until the water is "balanced". There are test strips that can be used to determine the correct chemical levels. http://www.ehow.com/how_4925553_install-spa-pool.html
yes, you could install a check valve on the line that feed the spa with water. it depends if that line has been buried or not how hard the job will be.
No it didn't have a spa but it did have a swimming pool
The check valve between the spa and the pool is defective.
Creative ways to get people in your pool and spa store?
One can purchase HTH pool and spa products directly from their website which will allow one to receive a lower price than from a retailer. One can also go to local pool and spa dealers who are registered to carry products from HTH pool and spa.
Tidy Pool and Spa is a nice pool service to have if you live in DSM, IA. When you have a pool service it makes owning a pool much nicer. Try out Tidy Pool and Spa.
One way would be to install drain tile in the yard around the pool deck to carry excess ground water away from the pool.
12
There are several pool cleaning services in the Boise area. Some of these include: Pool Doctor, Twin Dolphin Pool & Spa and Northwest Pools, Inc.
Pool or spa controls can be located just abut anywhere you see fit as long as they are installed to code.
I think you can as long as the yard is level, the concrete is in good condition and thick enough, and you use sand in the bottom of the pool. Consult your local pool shop for advice.
They like the fresh water - until the chlorine kills them. Best bet: Install a screen (or a short fence with some wire) between the yard and the pool.