0
Use something like Duct Tape to make a backing and fill the hole as much as possible with this. The use a putty knife to get the stucco material in the hole and to cover it, going up and down and side to side. You can then immediately paint over the patched spot, no need to wait on it to dry!
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Can landlord charge paint cost to patch many nail holes and half inch diameter holes in several rooms when itemize deduction from deposit after 4 years rent?
well yeah it can help, not make the house look alot better.😊
What do you use to fill large gaps in drywall?
Preferably you cut and fit a patch of drywall. I always do that for holes and gaps over 1/2 inch.
What the diameter of an inch?
An inch is a unit of measurement. It has no diameter.
What is the radius of a circle with a 12 inch diameter?
A circle with a 12 inch diameter has a 6 inch radius.
What is the circumference of a circle with a 38 inch diameter?
12 inch diameter(also 6 inch radius).
Convert diameter inch to linear inch?
An inch is an inch is an inch is an inch....
Would 25-inch-diameter tire or a 50-inch-diameter tire make more rotations when traveling 100 feet?
the 25-inch-diameter
How do you repair a furnace duct?
Contary to popular belief, 'duct' tape is not for fixing broken furnace ducts. It was originally developed for sealing the joints between duct sections, and is a poor substitute for properly riviting the sections together. If you have a large leak in a duct section, you might consider replacing the whole section rather than trying to patch it. If the leak is only a few inches in diameter, cut a piece of sheet metal about the same thickness as the metal of the duct, drill holes 1/8 inch in diameter around the perimeter of this piece, and then lay it on the duct. Using a marker of some sort, mark a few of the holes at one end of the patch, and drill the duct with the same 1/8 inch drill. Using a pop riveting tool, pop rivet the patch to the duct. Work from one end of the patch toward the other, never drilling more than 2 or 3 holes at a time before riveting them. Otherwise, the patch will end up not aligning with the holes that you have drilled, and you will have to make more holes in the duct. If the patch must go over an irregular surface, like an elbow, you may need to use silicone sealant to seal the spaces between the rivets.Be careful when drilling the duct that you do not press hard on the drill, as it could cause the duct to collapse. If you do not have any of the tools needed to perform this repair, consider calling a heating and air conditioning specialist.AnswerIt depends on what is wrong with the duct. Could you be more specific?
What is the inside diameter of a hydraulic tube with the outside diameter of 1 inch?
Less than an inch.
How many 0.50 inch diameter pipe will fit into one 1.50 inch diameter pipe?
Three 0.50 inch diameter pipes will fit into one 1.50 inch diameter pipe (hypothetically). The 0.50 inch diameters stack on top of each other until you have 1.50 inches!
What is the difference between 17 and 16 inch tires?
17 inch diameter rim versus 16 inch diameter rim
What is the gallons per inch in a 59.5 inch diameter cylinder?
A 59.5-inch diameter cylinder holds 1,733 gallons per inch of length/height.
