answersLogoWhite

0


Best Answer

It is quite common for rotors to be stuck in place. Tap on the back of the rotor with a hammer, until the rotor is loose.

User Avatar

Wiki User

โˆ™ 2014-10-06 22:37:31
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do I remove 1972 Corvette rear rotors that won't budge?
Write your answer...
Submit
Related questions

How do you change the radiator on a 1972 Corvette?

Drain the water from your 1972 Chevy Corvette radiator. Remove the radiator hoses. Remove the stabilizing arm retaining bolt. Remove the radiator retaining bolts. Reverse the process to install the new radiator.


Heater core change 1972 corvette with AC?

Remove the heater core retaining bolts. Remove the heater core water supply hoses. The heater core will come out. You can access the heater core in your 1972 Chevrolet Corvette through the passenger side kick plate.


How do you change rear tail lights on 1972 corvette?

remove the phlip screws in the lens. remove lens. push in on bulb while turning bulb out.


Will a 1978 Corvette door fit on a 1972 Corvette?

Yes.


Will 1972 Corvette t tops fit on a 1974 Corvette?

Yes.


Where is the battery located on a 1972 Corvette?

The battery location on a 1972 Corvette is behind the driver's seat. There is a small door behind the seat that hides the battery.


How much did the Corvette cost in?

1972


Is there a horn relay on a 1972 Corvette?

Yes sir there is s small horn relay on a 1972 Corvette. 1. I am a racing instructor 2. I own this car!


Where can one purchase a 1972 Corvette?

One can purchase a 1972 Corvette at Vette Finders. This website allows one to purchase and sell used Corvettes. So far there are only 2 1972 Corvettes on the website.


What year was the aluminum Corvette?

There was never a production Corvette made of aluminum. In 1972, GM built the XP 895 concept corvette from aluminum though.


Will an HEI distributor fit your 1972 corvette?

Yes, but you will need to remove any ballast resistor or resistance wire going from the ignition switch to the + side of the coil and replace it with copper.


What is the proper timing setting for a 1972 Corvette?

what motor do you have in it


What is the capacity of the fuel tank in a 1972 Corvette?

24 gallons


Will 1972 Corvette front clip fit a 1975 Corvette?

Yes. The 75 will have the plastic bumpers, so there will be subtle cosmetic differences, but, it will work.


How do you find the VIN history report on cars or in this case a corvette for 1972?

== ==


Where do you purchase a horn relay for a 1972 Corvette?

Ecklers- Titusville, FL


Will a 1972 corvette engine bolt into a 1973 Chevelle laguna?

sure.


How do you lower the steering column to remove the ignition switch on a tilt-telescopic 1972 Corvette?

Once you remove the dash plastic surround, you will find two bolts that hold the column up into the dash. As you loosen these bolts, the column will drop into your lap. I hope this helps you. Mark


What is the engine operating teperature for 1972 corvette 350 ci?

180F to 210F


What is the fuel tank size of 1972 corvette stringray?

17 US gallons


What is the number of cylinders in a 1972 Corvette?

There are 8. The firing order, if thats what you mean, is 1,8,4,3,6,5,7,2.


How do you change a 1972 Chevy Corvette heater core?

The heater core is on the passanger side, located behind the bower motor housing on the firewall. If the car doesn't have AC it is not a difficult project. Remove the heater hoses from the firewall and then remove the screws that attach the cover to the firewall. The heater core rests inside.


How do you change dead battery in a 1972 corvette?

The battery is located behind your driver seat. Pull the seat forward and lift the door up behind the seat disconnect the positive and negative cables then remove the hold down bar and lift out the battery.


How much gross horsepower does the 1985 Corvette have?

The American manufacturers don't go by gross hp, they completely changed to net hp in 1972. Net hp for the 1985 Chevrolet Corvette is 230hp.


Where is power window relay on a 1973 Corvette?

I have a 1972 Corvette and the power window relay is in the shifter console, just forward of the power window switches. I would believe it's in the same place in the '73. Good Luck