answersLogoWhite

0


Best Answer

You do not remoye the lens from the front of the car. head lamp bulbs are removed from the back of the assembly from inside the engine compartment. Note that your car has separate high beam and low beam bulbs. the ones toward the outside are low beam. Tip;do not handle the replacement lamp by touching the glass bulb ,only touch the plastic plug.you can damage the surface or connection.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do I remove the lens to change my headlamp on a 1993 Mazda 929?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change a headlamp in a 1993 Lexus SC400?

1 bolt on top of light. 2 bolts behind fender. remove dust cover in wheel well to reach fender bolts.


How do you change the starter on a 1993 Mazda MX-6?

remove air filter and air filter box and then you can get to starter dont forget to disconnect battery


How do you change the starter on a 1993 Mazda MX 6?

remove air filter and air filter box and then you can get to starter dont forget to disconnect battery


How do you change the thermostat on a 1993 Mazda mx3?

waste of time


I can't remove my old oil filter in my 1993 Mazda Protege. There's not enough leverage and space to turn it with a tool. How do I remove it?

get the proper one for a Mazda


How do you replace the heater core on a 1993 Mazda 929?

you have to remove the dash and every thing attached to it. Is it the same for a 1988 Mazda 929?


How do you get a key out of an ignition of a 1993 Mazda protege it is stuck and you cant even start it or remove the key?

i have no clue i have the same problem with my Mazda 1999 626


How do you change the clutch on a 1993 Mazda miata?

Pictorial guide: http://www.miata.net/garage/clutch2.html


Where is flasher unit in Mazda 323 Astina 1993?

The flasher unit on a Mazda 323 is located on the end of the flasher lever. Remove the lower steering column to bring the unit to view.


How do you change fuel pump on 1993 Chevy truck?

Remove the fuel tank or remove the bed.


How do you change the thermostat on a 1993 Mazda 626?

you have to remove the lower radiator hose and the thermostat is located between the radiator hose and engine block. There are two screws holding a mounting bracket over top of it to hold it in place. Remove the two screws and the thermostate should be accessible.


How do you tell if the starter or the flywheel ring is bad on a 1993 Mazda 626 lx?

Remove the starter and inspect the ring gear on the flywheel.