Ford F-150
How do I replace lower and upper ball joints on 1985 Ford F150?
Wiki User
April 01, 2009 6:04AM
you will probably need a ball joint press and a splitter
Related Questions
Asked in Suzuki Samurai
What are the timing marks for a 1985 samurai?
Take off the timing belt cover and you can see it, one upper and
one lower
Asked in Chevy Blazer, Ford Expedition XLT, Ford F-150
How do you remove and reinstall lower ball-joints on a 1985 ford f-150.?
you will need a tool called a pickel fork buy the new ones and
look at them
Asked in Starters and Ignition Systems, Chevy Trucks and SUVs, Ford F-150
How do you replace the ignition switch on a 1985 Chevy truck?
replace ighnition switch for 1985 chevlot
Asked in Hyundai Elantra, How To
How to Replace 1985 Hyundai elantra front axel?
How do you replace a 1985 Hyundai Elantra Front Axel
Asked in Thermostats, Buick Electra, Volvo 850
How do you replace the thermostat located on a 1985 Buick Electra?
It is at the engine end of the upper rad hose. Remove the
housing and there it is. When replacing it make sure the spring
goes toward the engine/
Asked in Oldsmobile
How do you replace a wheel berring on an 1985 Oldsmobile regency 98?
how do you replace a wheel bearing on an 1985 oldsmobile regency
98
Asked in GMC Sierra
How do you replace a fuel filter in a 1985 gmc high sierra?
how do you replace a fuel filter on a 1985 G.M.C. High
Sierra
Asked in Honda Motorcycles
How do you measure oil in a 1985 Honda dirt bike?
Use the dipstick. The oil level should be between the upper and
the lower lines on the dipstick when bike is standing upright on a
level surface.
Asked in Jeep Cherokee
How do you replace a fuel pump on a 1985 Jeep Cherokee?
Where is the fuel pump located on a 1985 jeep cherokee
Asked in Thermostats
How do you replace the thermostat located on a 1985 Ford Bronco II what side of the thermostat go?
how to replace a thermostat on a bronco 198511
Asked in Fuel Filters, Ford F-150
Should I replace the fuel filter for the 1985 Ford 150 4x4 XL?
Yes, replace it every 50,000 miles.
Asked in Pontiac Fiero
How do you replace a tcc on a 1985 fiero 2.8 v6?
Torque converter clutch?
Remove transmission
Replace Torque converter
Reinstall
Asked in Head Gaskets and Valve Covers, Mercury Grand Marquis, Ford F-150
How do you replace the valve cover gasket on a 1985 Grand Marquis?
You have to take those to the shop. I have one and tried and
messed up on it dont do what i did pleeease! you can do it no
problem. take off the upper intake manifold. the cover that says
5.0 EFI has 2 bolts underneath. 2 on the rear of the upper then 2
in the front. if it is the pass. side valve cover then flip the
upper over to the driver side watching out for the coolant hoses
and the vacuum hoses on the upper. mark all hoses. then go to town
on the valve cover.
Asked in Auto Parts and Repairs, Chevy Silverado, Heater Cores and Blower Fans, Ford Bronco XLT
How do you replace a heater core in a 1985 Mazda 626?
Get a manual on your car from AUTOBOOKSONLINE.COM.
Asked in Computers, Buick Skylark, Ford Explorer Sport
How do you replace the computer on a 1985 Buick Skylark?
You take it out and put a new one in
Asked in Chevy Caprice Classic
Change key tumbler in 1985 Chevrolet caprice?
Locksmith or replace locks
Asked in Timing Belts and Chains
Replacing a timing chain.?
How to replace a 1985 Chev Suburban's timing chain
Asked in Chevy Caprice Classic, Thermostats
Where is the thermostat located in a 1985 caprice classic?
Under the water manifold attached the upper radiator hose.
Asked in Cadillac DeVille
Where is the thermostat located on the 92 cadiiac deville?
Instructions given here are for all front wheel drive Cadillacs
from 1985 to 1995 with the 4.1, 4.5 or 4.9 motor.
Thermostat on the 92 DeVille 4.9 motor is captured between the
upper thermostat housing (it is usually black steel and the
radiator upper hose is clamped to it) and the lower (aluminum)
housing.
Cadillac Man
Asked in Shocks and Struts, Cadillac Fleetwood, Ford Explorer Limited, DIY Projects
How do you remove the front rear struts on a 1985 Cadillac Fleetwood FWD 4.1 liter?
most vehicles are the same when it comes to removing struts. on
fwd vehicles you need to remove both tires and detatch both lower
ball joints. if the vehicle has upper control arms i have found it
easier to remove those ball joint nuts, than to mess around with
the lower ones...then remove the axle from the spndle to gain
access to eht strut assembly retainer bolts. the remove the nuts
holding the upper mount in place for the strut. Rmove the lower
bolts that hold the strut to the spindle/ lower control arm. if it
conects directly to the spindle, MARK the bolt and hardware
positioning BEFORE removing the bolts (this helps with alignment
issues afterwords..then place the strut/spring assemble in a proper
coil spring remover and remove the spring, then replace the old
worn out strut with the new one (REMEMBER to match the parts up
before installation, saves on time and possible "no return"
items..) match the positions on the spring and the seat in the
strut...then reinstall the strut assembly back into the vehicle...
the rears are not much different...ENJOY
Asked in Starters and Ignition Systems, Mercury Grand Marquis, 1995-1999 Dodge & Plymouth Neons
Where is the location of a starter on a 1985 Mercury Marquis?
Look at the rear lower end of the engine
Asked in Chevy Celebrity
How do you fix shifter cable on 1985 Chevy Celebrity?
If the cable is broken you should replace it.
Asked in American Cars, Thermostats, Oldsmobile Cutlass Supreme, Nissan Murano
Where is the thermostat located in a 1985 cutlass supreme?
Look at the engine end of the upper radiator hose in a removable
housing