GET A NEW CAR. IT WOULD MOST LIKELY BE CHEAPER......
The ignition on a Chevrolet Cobalt will not turn with the key if it is does not correct align inside. This will block the cylinder from turning and prevent starting.
How to replace front middle grille in a 2006 cobalt ls
With the correct key.
i have a 06 Chevy cobalt and can't get the key out of the ignition switch
how to remove rear struts on 2005 chevy cobalt
I have 2008 and had same problem the ignition had to be replaced was really fast less than an hour they did it.
The ignition lock cylinder on a 2006 Chevy Cobalt is removed by popping off the steering column cover and inserting a screwdriver into the release hole. The cylinder can then be pulled from its housing and replaced.
open trunk...reach inside by the light assembly...loosen the wing nut type bolts....then loosen the 2 nuts by where the trunk meets the body on the trunk side...pull the entire assembly out....replace bulb.
Look above the license plate and find the bulb assembly, grasp the flat part turn it clockwise and pull it out, the bulb just pulls straight out.
Yes
Slightly turn the steering wheel and it should let you turn the key to on position
Undo old one, take out. Put in new one.