Windshield washer nozzles normally don't need replacing, If they are clogged, run a real fine wire through the opening to unclog them.
Windshield washer spray nozzles, or just simply nozzles.
They are attached to the underside of the hood, right in front of the windshield. They are quite easy to replace, if clogged. You'll find just a few small rubber hoses to remove that are slipped over the ends of the nozzles, supplying them with washer fluid from the pump.
They might be plugged with dirt, etc..
How do I remove a windshield washer pump from a toyota 4-runner 1988?
It is located on the bottom of the windshield washer reservoir.
On most vehicles, the same washer fluid reservour feeds the front and rear windshield nozzles - the one in the engine compartment.
either the washer motor has burned out or there is dirt in the washer lines plugging up the washer nozzles.
The dealer would be the first place I would check.
The nozzles pop in and out easily if you twist and slide them around.
how to replace the washer pump on a 2009 toyota camry
Windshield washer pump does not work? Check hoses to hood. If disconnected from nozzles, it will just spray the engine. also check to see if hoses are caught between something (crimped). If not, remove fender on pump reservoir side of vehicle, remove pump from side of reservoir and replace with a new one.
Windshield washer hose is attached on one end to the windshield washer reservoir pump and the other end to the spray nozzles. It is the same as every other car built in the last 50 years. --Ken