GM and GMC
How do I take the fan off of the water pump on a 1998 GMC pickup?
Asked in Dodge Avenger
How long does changing the water pump on a 1998 dodge avenger take?
How do you replace the water pump on a 1998 Pontiac Transport 3.4L?
Asked in Kia Sportage
How do you change a water pump on 1998 KIA sportage?
Asked in Chevy Silverado
How do you change a fuel pump on 1995 Chevy 1500 pickup?
Asked in Chevy Blazer, Water Pumps, Chevy Blazer S-10
How do install a water pump on a 1999 Chevy Blazer?
Asked in Jeep Liberty, How To
How to replace the water pump in a 2003 Jeep Liberty?
Asked in Cadillac Eldorado
Do you need to take the fan off to replace a water pump on a 1998 Cadillac Eldorado?
How do you change the water pump on a 1998 cadillac northstar?
Drain the cooling system. Remove the air filter housing. Remove the water pump belt and the water pump tensioner and any associated brackets. Unbolt and remove the water pump cover. Use a Northstar water pump socket (nothing else will work), rotate the water pump slightly clockwise, then pull it out. Replace the water pump seal. This usually is not included with the new water pump. Reverse the above steps to install the new water pump. Let me know if this helps. It looks like a hard job, but if you take your time it's pretty easy and doesn't take long. Don't rush or look for shortcuts.
Asked in Water Pumps, Pontiac Grand Am, Grand Am SE
How do you replace the water pump on a 1995 Pontiac Grand Am V6?
Asked in Home Electricity
How many watts of power does it take to run a water pump?
Asked in Chevy Camaro
How do you replace the water pump on a Chevy Camaro?
Asked in Nissan Sentra, Nissan Trucks and SUVs
How do you replace water pump on 1990 Nissan pickup?
Asked in Toyota MR2
Do you take off the timing cover on a mr2 when replacing the water pump?
Asked in Ford Contour, Water Pumps
How do you replace water pump on 1996 2.0L ford contour?
How do you replace the water pump on a 2000 Ford Explorer?
Asked in Water Pumps, Dodge Durango, Nissan Sentra
How do you replace the water pump on a 1994 Nissan Sentra?
Asked in Water Pumps, Chevy Monte Carlo
How do you replace the water pump on a 1998 Chevy Monte Carlo with 3100 engine?
take the serpentine belt loose and then take the pulley off the water pump and you will see all the bolts that hold the pump in, take the bolts out and pull the pump out, clean the engine surface real good where the pump mounts and put new gasket on the new water pump using permetex to hold it in place and let it dry for a few minutes and then put new pump on engine and reinstall the bolts and then the pulley and serpentine belt. Refill the cooling system with 50/50 water-antifreeze mix and start vehicle and open the bleeder valve directly in back of the water pump until fluid comes out and your done.
Asked in Mazda Protege
How do you install a water pump on a 1998 Mazda protege?
Asked in Dodge Ram
How do you remove bed from 1998 dodge ram 1500 pickup truck?
Asked in Chevy 305
How do you install an oilpump on a 1989 Chevy 305?
Take the oil pan off and remove the bolt that holds the pump to the thrust bearing cap. Install the new pickup on the new pump and verify the pickup location. It's a good idea to tack weld the pickup to the pump in a couple places. Install the pump driveshaft to the pump with a new connector. Install the new pump being careful to align the drive shaft with the distributor. Sometimes you have to turn the driveshaft and put it up in there a couple times until you get them lined up.