I hate to answer a question with another question, but what do you mean... How do I wire it?
Look at the rear drivers side of the transmission and you will see a round electronic sensor that is held into the side of the transmission with 1 bolt and clamp. it will have a electric wire pluged into it. That is the speed sensor.
white if its tbi
NO it does not. If it's not firing then you need to check the ignition module, pick-up coil and the coil. Could just have a bad coil wire......
Looking for the ESC myself....the Knock Sensor wire is blue though.
follow the red wire from the battery
Computer
It is on the driver side of the transmission tail housing. It is a two wire sensor.
Two wire sensor on right front of intake.
It is the two wire sensor on the lower rear driver side of the transmission.
It is screewed into the top of the engine block right behind the distributor. About 3 inches long with an electric wire pluged into the end of it. HARD TO SEE and to remove.
most small block Chevy trucks have used a dark green wire since around 1967 for the temp sensor on the side of the head, this went till at least 1995
That is the anti locking brake sensor / wheel speed sensor