Oxygen Sensors
Chevy Tahoe
Nissan Trucks and SUVs
Ford Explorer XLT

How do check the oxygen sensor on a 1989 Nissan pickup 4cylinder?

171819

Top Answer
User Avatar
Wiki User
2008-02-19 05:33:40
2008-02-19 05:33:40

install a new one!!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

its screwed into your exhaust manifold.

User Avatar

If the Nissan truck is either a V6 or a V8, the oxygen sensor will be located in the manifold. Sometimes it will be placed just below the manifold.

User Avatar

where is egr temp sensor located in 97 nissan pickup l4

User Avatar

its screwed into the exhaust manifold,undo wire and unscrew at manifold.

User Avatar

The intake air temperature sensor is built into the MAF sensor on a 1991 Nissan pickup. It is between the air box and the throttle body.

User Avatar

Its mounted on the transmission.

User Avatar

The only way to reset the sensor light on a 1985 Nissan pickup truck is to disconnect the sensor wiring. After 60 seconds, put the wiring back in place.

User Avatar

The 1997 Nissan pickup truck crankshaft position eight sensor can be found on the back of the engine. The positioning sensor will be halfway down the engine block.

User Avatar

its screwed into the exhaust manifold. On the driver side below the spark plugs closest to the firewall .

User Avatar

you have 3 of them ,1in each exhaust manifold and 1 in one of the pipe leaving the exhaust manifold.

User Avatar

Its up in under there somewhere

User Avatar

There is a fuel temp sensor mounted on a bracket inside the tank and a low fuel sensor on the fuel pickup assy...

User Avatar

in the gas tank, it is part of the fuel level sensor

User Avatar

If someone could please explain who to get to the oxygen sensor and explain where it is for sure?

User Avatar

It is part of the distributor. You have to replace the distributor

User Avatar

You need to take a wrench to loosen the oxygen sensor, then you will need to disconnect the cord. Once you have done that you will then pull out the old oxygen sensor.

User Avatar

P0141 - O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 2)

User Avatar

right below your thermostat housing

User Avatar

Front top of the intake manifold.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.